HCD-MJ1, HCD-MJ1A - Sony Audio Service Manual (repair manual). Page 12

– 12 –

5-5-2. Operating the Continuous Recording Mode
1. Entering the continuous recording mode

1 Set the MO disc in the unit.
2 Rotate the JOG dial knob and display “CREC MODE”.
3 Press the YES button to change the display to “CREC IN”.

           

4 When access completes, the display changes to “CREC (        ) and 

 REC

 lights up.

 The “   ”  displayed are arbitrary numbers.

2. Changing the parts to be recorded

          

1 When the YES button is pressed during continuous recording. the display changes to “CREC MID”, “CREC OUT”and  

REC

  goes off.

     When pressed another time, the parts to be recorded can be changed.

           

2 When access completes, the display changes to “CREC (        ) and  

REC

  lights up.

Note : The “   ”  displayed are arbitrary numbers.
3. Ending the continuous recording mode

1 Press the No bottan. The display change to CREC MODE” and 

REC

 goes off.

2 Press the  MD § button and remove the disc.

 The recording start addresses for IN, MID, and OUT are as follows.

IN

  40h cluster

MID

300h cluster

OUT

700h cluster

 The No buttton can be used to stop recording anytime.

During the test mode, the erasing-protection tab will not be detected. Therefore be careful not to set the continuous recording mode
when a disc not be erased is set in the unit.

Do not perform continuous recording for long periods of time above 5minutes.

During continuous recording, be careful not to apply vibration.

5-5-3. Non-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the nonü]volatile memory.
It is not used in servicing. If set accidentally, press the No button immediately to exit it.

^

Sets continuous playback when pressed in the STOP state.

When pressed during continuouse playback,the tracking servo turns ON/OFF.

p

Stops continuouse playback and continuouse recording.

)

The sled moves to the outer circumference only when this is pressed.

0

The sled moves to the inner circumference only when this is pressed.

r

Turns recording ON/OFF when presed during continuoos playback.

SCROOLL

Switches butween the pit and groove modes when pressed.

DISPLAY

Switches the display whin pressed. Returns to previous step. Stops operations.

The erasing-protection tab is not detected during the test mode. Recording will start regardless of the position of the erasing-protection
tab when the 

r (REC) button is pressed.