Read Sony HCD-GZR33D / HCD-LCD7DI / LBT-LCD7DI / MHCGZR33DI Service Manual online
Perform solder bridging to prevent damage by electrostatic
discharge when handling the BU as a single unit.
discharge when handling the BU as a single unit.
1
2
As illustrated, insert a flathead screwdriver
and give a turn to the left to put the tray out.
and give a turn to the left to put the tray out.
flathead screwdriver
CD tray
HCD-GZR33D/LCD7Di
6
SECTION 1
SERVICING NOTES
Notes on Disconnecting Between the OP Section (DVBU101) and the DMB19 Board
Note: When disconnecting between the OP section (DVBU101) and the DMB19 board, be sure to make a solder brige for electrostatic
Note: When disconnecting between the OP section (DVBU101) and the DMB19 board, be sure to make a solder brige for electrostatic
prevention as illustrated in the fi gure (before disconnection).
On the contrary, when installing the OP section, never remove the solder bride until the OP section and the DMB19 board are
connected.
Be sure to remove the solder bridge after the OP section and the DMB19 board have been connected.
Manual Opening and Closing the CD Tray
As illustrated, insert a fl athead screwdriver and give a turn to the left to put the CD tray out.
As illustrated, insert a fl athead screwdriver and give a turn to the left to put the CD tray out.
Click on the first or last page to see other HCD-GZR33D / HCD-LCD7DI / LBT-LCD7DI / MHCGZR33DI service manuals if exist.