HCD-GRX2, HCD-RX33, MHC-GRX2, MHC-RX33 - Sony Audio Service Manual (repair manual). Page 3

— 3 —

After correcting the original service problem, perform the following
safety checks before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs, screws,
and all other exposed metal parts for AC leakage. Check leakage as
described below.

The AC leakage from any exposed metal part to earth Ground and
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microampers).
Leakage current can be measured by any one of three methods.
1.

A commercial leakage tester, such as the Simpson 229 or RCA
WT-540A. Follow the manufacturers’ instructions to use these
instruments.

2.

A battery-operated AC milliammeter. The Data Precision 245
digital multimeter is suitable for this job.

3.

Measuring the voltage drop across a resistor by means of a
VOM or battery-operated AC voltmeter. The “limit” indication
is 0.75 V, so analog meters must have an accurate low-voltage
scale. The Simpson 250 and Sanwa SH-63Trd are examples of
a passive VOM that is suitable. Nearly all battery operated
digital multimeters that have a 2V AC range are suitable. (See
Fig. A)

To Exposed Metal 

Parts on Set

0.15 

µ

F

1.5 k

Ω

AC
Voltmeter
(0.75 V)

Earth Ground

Fig. A.  Using an AC voltmeter to check AC leakage.

.......................................................................... 4

2-1.

CD Door ............................................................................. 5

2-2.

CD Mechanism Deck ......................................................... 5

2-3.

Front Panel ......................................................................... 6

2-4.

Main Board and H.P Board ................................................ 6

2-5.

CD Tray .............................................................................. 7

2-6.

CD Decoder Board ............................................................. 7

2-7.

Base Unit ............................................................................ 8

2-8.

Cassette Lid (L)/(R) ............................................................ 8

............................... 9

................................. 9

5-1.

Circuit Boards Location ................................................... 14

5-2.

Brock Diagrams

• Deck Section ................................................................... 15
• Tuner/CD Section ............................................................ 17

5-3.

IC Brock Diagrams ........................................................... 19

5-4.

Schematic Diagram —Main Section — ........................... 24

5-5.

Printed Wiring Board — Main Section — ....................... 29

5-6.

Printed Wiring Board —CD Section — ........................... 34

5-7.

Schematic Diagram —CD Section — .............................. 39

5-8.

Schematic Diagram — Panel Section — ......................... 43

5-9.

Printed Wiring Board —Panel Section — ........................ 47

5-10. IC Pin Function ................................................................ 52

6-1.

Cabinet Section ................................................................. 54

6-2.

Front Panel Section .......................................................... 55

6-3.

Cassette Button Section .................................................... 56

6-4.

Cassette Mechanism Deck Section ................................... 57

6-5.

CD Mechanism Deck Section 1 ....................................... 58

6-6.

CD Mechanism Deck Section 2 ....................................... 59

6-7.

Base Unit Section (KSM-213BCM) ................................. 60

........................................ 61