HCD-DP700, MHC-DP700 - Sony Audio Service Manual (repair manual). Page 14

14

• The sequence during the aging mode is following as below.
• If an error occurred, stop display that step.

6. When the check is complete, a message of either OK or NG

appears.

* To return to normal mode again.
1. When you want to exit this mode, press the  POWER  button.
2. The cold reset is enforced at the same time.

This mode can for operation check of tape deck section and CD

section.

• If an error occurred:
 The aging operation stops and display then status.
• If no error occurs:
The aging operation continues repeatedly.
Procedure:
1. Press the  CD  button to select the function “CD”.
2. Load the tapes into the decks A and B respectively.
3. Set a disk in “DISK1” tray.
4. Press the  PLAY MODE  button to set the “ALL DISCS” mode,

and press the  REPEAT  button to “REPEAT” off.

5. Press three buttons of  STOP ,  ENTER , and  DISC SKIP/EX-

CHANGE  simultaneously.

6. The aging mode is activated, if the indicator of DOLBY NR is

blinking.

7. To exit from the aging mode, operate the cold reset.

FWD play the tape A

“TAPE A AG-2”

Fast forward the tape A

“TAPE A AG-3”

RVS play the tape A

“TAPE A AG-4”

Rewind the tape A

“TAPE A AG-5”

FWD play the tape B

“TAPE B AG-2”

Rewind the tape A and B

“TAPE A AG-1”

Fast forward the tape B

“TAPE B AG-3”

RVS play the tape B

“TAPE B AG-4”

Rewind the tape B

“TAPE B AG-5”

Shut off

2 minutes

Shut off or 20 seconds

2 minutes

Shut off

2 minutes

Shut off or 20 seconds

2 minutes

Shut off