HCD-BC150, HCD-BC250 - Sony Audio Service Manual (repair manual). Page 18

18

In order to execute mirror time adjustment, the following standard
procedures must be followed.

(1) In standby mode, press three buttons  x  ,  A (DISC1) and

 ?/1  simultaneously.

(2) Select “2. Drive Manual Operation” by pressing the  2
      key on the remote commander. The screen will appear as
      below.

(3) Select “3. Manual Adjustment” by pressing the  3  key on
the remote commander. The screen will appear as below.

(4) Select Iop by pressing  6  key on the remote commander.

Remocon Diagnosis Menu

0. External Chip Check
1. Servo Parameter Check
2. Drive Manual Operation
3. Emergency History Check
4. Version information
5. Video Level Adjustment

Model

: DPX-1790_UC2

IF-con  Ver

: 1.000 (5B84)

Syscon  Ver : 1.81

Drive Manual Operation

1. Servo Control
2. Track/Layer Jump
3. Manual Adjustment
4. Tray Aging Mode
5. MIRR time adjust
0. Return to top Menu

Manual Adjust

1. Track Balance Adjust:
2. Track Gain Adjust:
3. Focus Balance Adjust:
4. Focus Gain Adjust:
5. Eg boost Adjust:
6. Iop:
7. TRV. Level:
8. S curve(FE) Level:
9. RFL(PI) Level:
0. MIRR Time:

o

  O    Change Value

[RETURN] Return to previous menu

(5) Wait until a hexadecimal number appear.

(6) Convert each data from hexadecimal to decimal using
      conversion table.

(7) Substract between these two values.

(8) If the remainder is smaller than 93 (decimal), then it is
      OK. However if the value is higher than 93, then the BU
      is defective and need to be change.

(9) Press  RETURN  to return back to previous menu.

(10) Press 0 to return to Top Menu and power OFF the DVD
      Player.

Manual Adjust

1. Track Balance Adjust:
2. Track Gain Adjust:
3. Focus Balance Adjust:
4. Focus Gain Adjust:
5. Eq Boost Adjust:
6. Iop. ED 9E:
7. TRV. Level:
8. S curve(FE) Level:
9. RFL(PI) Level:
0. MIRR Time:

Change Value
[0] Return to previous menu