Read Sony HBD-TZ140 Service Manual online
HBD-TZ140
12
2-7. DVD MECHANISM DECK BLOCK
3 Solder the short-land.
2 connector
(CN301)
(CN301)
<Fig. A>
4 flexible cable
(CN300)
(CN300)
7 Remove the DVD
mechanism
mechanism
deck
block in the direction
of the arrow.
8 DVD mechanism deck block
1 Cut two wire ties. <Fig. A>
<Fig. A>
Note 3:
When assembling the optical
pick-up block, remove the solder
of short-land after connecting the
flexible
cable.
Note 2:
In reassembling,
use new wire tie
to fasten the clamp
same as before.
5 two screws
(BVTT3
(BVTT3
u 7)
5 two screws
(BVTT3
(BVTT3
u 7)
6 claw
6 claw
– Rear right view –
Wire setting
(Former type)
wire tie
wire tie
tray
CONTROL board
MAIN board
POWER board
DVD mechanism deck
Bring the slack part to the front side.
Check that this portion is not slack.
This portion must not touch the POWER board.
This portion must not touch the POWER board.
This portion must not touch the tray.
Note 7: When installing the flexible
flat cable, ensure the colored
line. No slanting after insertion.
Note 6: When installing the flexible flat cable,
check that the terminal is not damaged.
Terminal is damaged.
Insert is straight to the interior.
Insert is incline
flexible flat
cable
cable
OK
NG
Note 5: When you install the connector, please install them
correctly. There is a possibility that this machine
damages when not correctly installing it.
Insert is shallow
Insert is straight
to the interior.
to the interior.
connector
Insert is incline
connector
connector
connector
connector
connector
NG
OK
NG
connector
flexible flat
cable
cable
connector
OK
NG
Ver. 1.4
Note 1: When disconnecting the fl exible cable of optical pick-up block, solder the
short-land.
Note 4: The DVD mechanism deck for this unit has been
changed in the midway of production. About the
New/Former discrimination, refer to “ABOUT
THE DVD MECHANISM DECK” on page 5.
New/Former discrimination, refer to “ABOUT
THE DVD MECHANISM DECK” on page 5.
Click on the first or last page to see other HBD-TZ140 service manuals if exist.