Read Sony DHC-FLX9W / HCD-FLX9W Service Manual online
116
HCD-FLX9W
Pin No.
Pin Name
I/O
Description
40
VDDI
—
Power supply terminal (+3.3V)
41
VSS
—
Ground terminal
42
GP15
O
Column address strobe signal output terminal Not used
43
OE0
O
Output enable signal output to the S-RAM
44
CS0
O
Chip select signal output to the S-RAM
45
WE0
O
Write enable signal output to the S-RAM
46
VDDE
—
Power supply terminal (+3.3V)
47
WMD1
I
S-RAM wait mode setting terminal Fixed at “H” in this set
48
VSS
—
Ground terminal
49
WMD0
I
S-RAM wait mode setting terminal Fixed at “L” in this set
50
PAGE2
O
Page selection signal output terminal Not used
51
VSS
—
Ground terminal
52, 53
PAGE1, PAGE0
O
Page selection signal output terminal Not used
54
BOOT
I
Boot mode control signal input terminal Not used
55
BTACT
O
Boot mode state display signal output terminal Not used
56
BST
I
Boot trap signal input from the digital audio interface receiver
57
MOD1
I
PLL input frequency select terminal “L”: 384fs, “H”: 256fs (fixed at “H” in this set)
58
MOD0
I
Mode setting terminal “L”: single chip mode, “H”: use prohibition (fixed at “L” in this set)
59
EXLOCK
I
PLL lock error and data error flag input from the digital audio interface receiver
60
VDDI
—
Power supply terminal (+3.3V)
61
VSS
—
Ground terminal
62, 63
A17, A16
O
Address signal output terminal Not used
64 to 66
A15 to A13
O
Address signal output to the S-RAM
67
GP10
O
L/R sampling clock signal (44.1 kHz) output to the D/A, A/D converter and digital filter
Not used
Not used
68
DECODE
O
Decode signal output to the system controller
69
AUDIO
I
Bit 1 input terminal of channel status from the digital audio interface receiver
70
VDDI
—
Power supply terminal (+3.3V)
71
VSS
—
Ground terminal
72 to 75
D15 to D12
I/O
Two-way data bus with the S-RAM
76
VDDE
—
Power supply terminal (+3.3V)
77 to 80
D11 to D8
I/O
Two-way data bus with the S-RAM
81
VSS
—
Ground terminal
82 to 85
A9, A12 to A10
O
Address signal output to the S-RAM
86
TDO
O
Simple emulation data output terminal Not used
87
TMS
I
Simple emulation data input start/end detection signal input terminal Not used
88
XTRST
I
Simple emulation asychronous break input terminal Not used
89
TCK
I
Simple emulation clock signal input terminal Not used
90
TDI
I
Simple emulation data input terminal Not used
91
VSS
—
Ground terminal
92 to 97
A8 to A3
O
Address signal output to the S-RAM
98, 99
D7, D6
I/O
Two-way data bus with the S-RAM
100
VDDI
—
Power supply terminal (+3.3V)
101
VSS
—
Ground terminal
102 to 105
D5 to D2
I/O
Two-way data bus with the S-RAM
106
VDDE
—
Power supply terminal (+3.3V)
Click on the first or last page to see other DHC-FLX9W / HCD-FLX9W service manuals if exist.