DHC-AZ77DBT, HCD-AZ77DBT - Sony Audio Service Manual (repair manual). Page 10

Read Sony DHC-AZ77DBT / HCD-AZ77DBT Service Manual online

HCD-AZ77DBT
10
Setting the clock
Use buttons on the remote to set the 
clock.
1
Press /
 to turn on the 
system.
2
Press TIMER MENU 
.
The hour indication flashes in the 
display.
If “PLAY SET?” flashes in the display,
press
or
repeatedly to select
“CLOCK SET?,” then press ENTER 
.
3
Press  or 
 repeatedly to set 
the hour.
4
Press ENTER 
.
The minute indication flashes in the 
display.
5
Press  or 
 repeatedly to set 
the minutes.
6
Press ENTER 
.
The clock starts functioning.
Notes
The clock settings are canceled when you
disconnect the power cord or if a power
failure occurs.
You cannot set the clock when using 
Bluetooth headphones. Cancel the Bluetooth
connection.
The clock setting mode is canceled when 
passkey entry is required from a Bluetooth
device. Turn off the Bluetooth device.
To display the clock when the system 
is off
Press DISPLAY
.
The clock is displayed for about 8 
seconds.
Rear panel
S VIDEO OUT jack
Connect the S Video input jack of
the TV. You can enjoy higher quality
video images when you select the 
S VIDEO.
VIDEO OUT jack
Connect the video input jack of the 
TV or projector.
COMPONENT VIDEO OUT jacks
Connect the component video input
jacks of the TV or projector. If your
TV accept progressive format signals, 
you must use this connection and 
press PROGRESSIVE
on the unit
repeatedly to select “P AUTO” or “P
VIDEO.” You can enjoy higher quality
video images.
VIDEO/SAT OUT L/R jacks
Connect the audio input jacks of an
optional component (such as VCR or
MD deck).
VIDEO/SAT IN L/R jacks
Connect the audio output jacks of an
optional component (such as VCR or
satellite tuner).
SUBWOOFER OUT jack
Connect the audio input jack of an
optional subwoofer*.
* SA-GNV111D is recommended. In some
areas, the SA-GNV111D may not yet be
available.
Note
The effect may be limited or noise may
occur depending on the connected
subwoofer or the type of music being 
played back.
D-LIGHT SYNC OUT jack 
(Except for Australian model)
Connect the D-LIGHT SYNC
controller (not supplied). You need
to connect the D-LIGHT SYNC
controller to the lighting device* (not
supplied). The lighting device will
react according to control signals
transmitted by the D-LIGHT SYNC
controller upon receiving music
source from the system. For details
on the use of D-LIGHT SYNC
controller and lighting device, refer to
the respective operating instructions
supplied with the respective device.
* Refer to the D-LIGHT SYNC
controller operating instruction for the 
recommended lighting device.
Note
The lighting effect may be different
depending on the connected lighting
device or the type of music being played
back.
Page of 125
Display

Click on the first or last page to see other DHC-AZ77DBT / HCD-AZ77DBT service manuals if exist.