Read Sony DAV-SZ1000W / HBD-SZ1000W (serv.man2) Service Manual online
1. The E4.2V form the SUB POWER TRANSFORMAER is provided to the RESET
IC(IC5004) and the RESET SW(Q5001). IC5002 then boots up by sending the
system reset signal to the SYSTEM CONTROL(IC5002 12pin).
system reset signal to the SYSTEM CONTROL(IC5002 12pin).
2. The operation clock of SYSTEM CONTROL(IC5002) is 8MHz(X5001). The
p
(
)
(
)
SYSTEM CONTROL boots up by reading embedded firmware. This firmware can
be updated by following a specific procedure.
be updated by following a specific procedure.
3. When the SYSTEM CONTROL(IC5002) boots up properly, the LED lights up by
LED_PWM terminal(28pin).
(Note) How to check if booted properly.
•
When the SYSTEM CONTROL(IC5002) boots up properly, “DEMO” will be
indicated on the display of the main unit. If “DEMO” is not displayed, you need to
check the power input signal to the SYSTEM CONTROL(IC5002).
indicated on the display of the main unit. If “DEMO” is not displayed, you need to
check the power input signal to the SYSTEM CONTROL(IC5002).
6
Page
Click on the first or last page to see other DAV-SZ1000W / HBD-SZ1000W (serv.man2) service manuals if exist.