DAV-IS10, SA-WSIS10, SS-IS10 - Sony Audio Service Manual (repair manual). Page 3

3

When the SA-WSIS10 is checked, connect to HCD-IS10 (for DVD
receiver of DAV-IS10). Be sure in advance the HCD-IS10 is
prepared.

To connect with SA-WSIS10 and to use it, SS-IS10 is designed.
Therefore, when it connects with a usual amplifier and the audio
signal of an excessive low-frequency (800 Hz or less) is input, there
is a possibility that the speaker breaks.
When you confirm the output with large audio signal input, connect
SA-WSIS10 with SS-IS10.

MODEL

PART No.

US model

3-096-898-0[]

Canadian model

3-096-899-0[]

AEP and UK models

3-096-901-0[]

Russian model

3-113-067-0[]

Singapore model

3-113-068-0[]

Latin America models

3-113-069-0[]

except Argentina

Taiwan model

3-113-093-0[]

Saudi Arabia model

3-113-094-0[]

Australian model

3-113-095-0[]

Argentina model

3-113-096-0[]

Chinese model

3-113-097-0[]

Thai model

3-272-500-0[]

Part No.

Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with

the lead free mark due to their particular size)

Unleaded solder has the following characteristics.

•

Unleaded solder melts at a temperature about 40 

°

C higher

than ordinary solder.

Ordinary soldering irons can be used but the iron tip has to be

applied to the solder joint for a slightly longer time.

Soldering irons using a temperature regulator should be set to

about 350 

°

C.

Caution: The printed pattern (copper foil) may peel away if

the heated tip is applied for too long, so be careful!

•

Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)

than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.

•

Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may

also be added to ordinary solder.