Read Sony DAV-DZ370 / DAV-DZ560 / DAV-DZ570 / DAV-DZ660 / DAV-DZ777 / HCD-DZ370 / HCD-DZ560 / HCD-DZ570 / HCD-DZ660 / HCD-DZ777 Service Manual online
Logic (II) adaptive matrix surround decoder and the DTS** Digital
Surround System.
* Manufactured under license from Dolby Laboratories.
of Dolby Laboratories.
of DTS, Inc.
FL/FR/C/SL/SR*:
FL/FR/C/SL/SR*:
FL/FR/C/SL/SR*:
FL/FR/C/SL/SR*:
source, there may be no sound output.
TV/VIDEO (AUDIO IN) Sensitivity: 450/250 mV
AUDIO IN
TV (AUDIO IN)
TV (AUDIO IN)
TV (AUDIO IN)
AUDIO IN
TV/VIDEO (COAXIAL IN/OPTICAL IN)
TV (COAXIAL IN/OPTICAL IN)
Phones
Signal format system
Mexican and Latin American models:
NTSC
Other models:
MP3 (MPEG 1 Audio Layer-3):
REPLACE THESE COMPONENTS WITH SONY PARTS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
MP3 (MPEG 1 Audio Layer-3):
32/44.1/48
FM tuner section
Tuning range
North American models: 87.5 MHz - 108.0 MHz
Intermediate frequency
Tuning range
North American, Mexican, and Latin American
models:
Mexican models:
DC
700
without notice.
The components identifi ed by mark
Strictly follow the instructions whenever the components are re-
paired and/or replaced.
AUS :
– Back Panel –
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
• Unleaded solder melts at a temperature about 40 °C higher
applied to the solder joint for a slightly longer time.
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if the
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
also be added to ordinary solder.
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
• Keep the temperature of soldering iron around 270 °C during
ing the limit for Class 1.
CLASS 1 LASER product.
This marking is located on the
rear or bottom exterior.
Use of controls or adjustments or performance of procedures other than
those specifi ed herein may result in hazardous radiation exposure.
also use the controls on the unit if they have the
same or similar names as those on the remote.
RW/DVD-R.
function, which allows transmission of sound
between S-AIR products wirelessly.
The following S-AIR products can be used with
the system:
option (the S-AIR product lineup differs
depending on the area).
or S-AIR receiver in this operating instructions
refer only to when the surround amplifier or
S-AIR receiver is used.
For details on the S-AIR function, see “Using an
S-AIR Product”.
Recording) mode
DVD-R DL)
• CD-R/CD-RW/CD-ROM in video
files
DVD format, containing MP3
files
Disk Format)