Read Sony CPF-IX001 / NAS-IX001P Service Manual online
14
NAS-IX001P
5. Press the
.
/
>
key on the remote commander to select
the output tone. (see below list)
Test tones:
Normal Music
Normal Music
: Don’t use.
1kHz 0db L+R
: Output 1 kHz, 0 dB, L and R-ch
1kHz 0db L
: Output 1 kHz, 0 dB, L-ch only
1kHz 0db R
: Output 1 kHz, 0 dB, R-ch only
Sweep Low L+
: Sweep output low tone, L and R-ch*
Sweep Low L
: Sweep output low tone, L-ch only*
Sweep Low R
: Sweep output low tone, R-ch only*
Sweep Mid L+
: Sweep output mid tone, L and R-ch*
Sweep Mid L
: Sweep output mid tone, L-ch only*
Sweep Mid R
: Sweep output mid tone, R-ch only*
Sweep Hi L+R
: Sweep output high tone, L and R-ch*
Sweep Hi L
: Sweep output high tone, L-ch only*
Sweep Hi R
: Sweep output high tone, R-ch only*
*) It takes 40 seconds till the sweep output start sounds.
6. Press the [ENTER] key on the remote commander to execute
the selected item.
7. To change the sound, press the [ENTER] or [MENU] key on the
remote commander to return one step before, and repeat the
step 5.
step 5.
1-2. Wireless LAN test
Note1:
For connecting check of wireless LAN, perform the Radio
Reception Check of the “SERVICING NOTES” in conjunction with
this test too.
Reception Check of the “SERVICING NOTES” in conjunction with
this test too.
Note2:
For network setting, refer to the Operating Instructions and Quick
Setup Guide of the CPF-IX001.
Setup Guide of the CPF-IX001.
Setting:
[WIRELESS/WIRED] switch: WIRELESS
Network cable:
Network cable:
Disconnect
Network environment:
Wireless LAN
Procedure:
1. Enter the test mode.
2. With the state that “NETWORK?” is displayed, press the
2. With the state that “NETWORK?” is displayed, press the
[ENTER] key on the remote commander to enter the Network
test mode.
test mode.
3. Press the
>
key on the remote commander to display
“DENPA?”.
4. Press the [ENTER] key on the remote commander to display
the condition of radio reception as following figure.
Note:
If any one value in above 3 values is “0”, it means no link.
2.
Version Display Mode
Procedure:
1. Enter the test mode.
2. Press the
2. Press the
>
key on the remote commander to display
“VERSION?”.
3. Press the [ENTER] key on the remote commander to display
the GC version.
3.
Display Test Mode
Procedure:
1. Enter the test mode.
2. Press the
2. Press the
>
key on the remote commander to display
“DISPLAY?”.
3. Press the [ENTER] key on the remote commander to enter the
display test mode.
4. In this mode, it displays as following figure.
Flow in The Display Test Mode:
R00 N00 00
Link speed (Mbps)
Noise floor level (dBm)
RSSI (Received signal strength
indicator) (dBm)
indicator) (dBm)
pattern 1
All light up
pattern 2
mode in
mode out
>
key
>
key
>
key
ENTER
key
ENTER
key
ENTER
key
Click on the first or last page to see other CPF-IX001 / NAS-IX001P service manuals if exist.