Read Sony CMT-NEZ3 / CMT-NEZ5 / HCD-NEZ3 / HCD-NEZ5 (serv.man3) Service Manual online
10
HCD-NEZ3/NEZ5
4.
ELECTRICAL ADJUSTMENTS
2. Turn the adjustment screw and check output peaks. If the peaks
do not match for L-CH and R-CH, turn the adjustment screw
so that outputs match within 1dB of peak.
so that outputs match within 1dB of peak.
3. Mode: Playback
4. After the adjustments, apply suitable locking compound to
the pats adjusted.
Adjustment Location: Record/Playback/Erase Head
1. Demagnetize the record/playback head with a head
demagnetizer.
2. Do not use a magnetized screwdriver for the adjustments.
•
Test Tape
Tape
Signal
Used for
P-4-A063
6.3 kHz, -10 dB
Azimuth Adjustment
RECORD/PLAYBACK HEAD AZIMUTH ADJUSTMENT
Note:
Remove the cassette lid assy before this adjustment.
Procedure:
1. Mode: Playback
0 dB=0.775 V
DECK SECTION
set
HEAD PHONE board
PHONES jack
(J500)
PHONES jack
(J500)
+
–
–
level meter
test tape
P-4-A063
(6.3 kHz, –10 dB)
P-4-A063
(6.3 kHz, –10 dB)
set
test tape
P-4-A063
(6.3 kHz, –10 dB)
P-4-A063
(6.3 kHz, –10 dB)
oscilloscope
V
H
waveform of oscilloscope
in phase 45
°
90
°
135
°
180
°
good
wrong
HEAD PHONE board
PHONES jack
(J500)
PHONES jack
(J500)
Screw
position
position
L-CH
peak
peak
within
1dB
1dB
Output
level
level
L-CH
peak
peak
R-CH
peak
peak
within
1dB
1dB
Screw
position
position
R-CH
peak
peak
Click on the first or last page to see other CMT-NEZ3 / CMT-NEZ5 / HCD-NEZ3 / HCD-NEZ5 (serv.man3) service manuals if exist.