Read Sony CMT-M80V / HCD-M80 Service Manual online
4
HCD-M80
SECTION 1
SERVICING NOTES
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
BLOCK OR BASE UNIT
MODEL IDENTIFICATION
– Back Panel –
– Back Panel –
SERVICE POSITION
In checking the tape deck section, prepare jig (extension cable J-
2501-167-A: 1.25 mm Pitch, 17 cores, Length 300 mm).
2501-167-A: 1.25 mm Pitch, 17 cores, Length 300 mm).
Part No.
Model Name
Part No.
Singapore model
4-238-890-0
[]
Thai model
4-238-891-0
[]
Saudi Arabia model
4-241-755-0
[]
TC board (CN301)
main board (CN301)
Connect jig (extension cable J-2501-167-A)
to the main board (CN301) and TC board (CN301).
to the main board (CN301) and TC board (CN301).
Ver 1.1
RELEASING THE DISC TRAY LOCK
The disc tray lock function for the antitheft of an demonstration
disc in the store is equipped.
disc in the store is equipped.
Releasing Procedure :
While pressing the
While pressing the
[DSG]
key, press the
[ CD]
key for 5 seconds.
The message “UNLOCKED” is displayed and the tray is unlocked.
Note:
When “LOCKED” is displayed, the tray lock is not released by
turning power on/off with the
turning power on/off with the
I
/
1
button.
Z
Click on the first or last page to see other CMT-M80V / HCD-M80 service manuals if exist.