CMT-M100MD, HCD-M10 - Sony Audio Service Manual (repair manual). Page 6

6

This appliance is classified as a CLASS 1 LASER product. The
CLASS 1 LASER PRODUCT MARKING is located on the rear
exterior.

Laser component in this product is capable
of emitting radiation exceeding the limit for
Class 1.

Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.

• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be

damaged by heat.

The negative speaker outputs are not grounded bevause of the

balanced transformerless circuit.

(If connecting them to ground, or each other, the circuit is broken)

The laser diode in the optical pick-up block may suffer electrostatic
break-down because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.

The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.

Never look into the laser diode emission from right above when
checking it for adjustment. It is feared that you will lose your sight.

This caution
label is
located inside
the unit.

The disc tray lock function for the antitheft of an demonstration
disc in the store is equipped.

Releasing Procedure :
1.

Press two buttons of   ENTER/START   and   OPEN/CLOSE
(CD section) simultaneously.

2.

The message “UNLOCKED” is displayed and the tray is
unlocked.

Note : When “LOCKED” is displayed, the tray lock is not released

    by turning power on/off with the  POWER  button.