Read Sony CMT-EP305 / HCD-EP305 Service Manual online
2
This appliance is classified as a CLASS 1 LASER product. The
CLASS 1 LASER PRODUCT MARKING is located on the rear
exterior.
CLASS 1 LASER PRODUCT MARKING is located on the rear
exterior.
The following caution label is located inside the unit.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
other than those specified herein may result in hazardous radiation
exposure.
HCD-EP305
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK
0
OR DOTTED LINE WITH
MARK
0
ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
TABLE OF CONTENTS
1. SERVICING NOTES
······················································ 3
2. GENERAL
·········································································· 4
3. DISASSEMBLY
································································ 6
3-1.
Front Panel Section ...................................................... 6
3-2.
MAIN Board ................................................................ 7
3-3.
Tape Mechanism Deck (TCM125-2) ........................... 7
3-4.
POWER Board, Power Transformer ............................ 8
3-5.
DISPLAY Board, HEADPHONE Board ..................... 8
3-6.
CD Cabinet Section ...................................................... 9
3-7.
CD Mechanism Deck (CS-21SC-1280) ....................... 9
3-8.
Cassette Lid ................................................................ 10
4. MECHANICAL ADJUSTMENTS
····························· 11
5. ELECTR ICAL ADJUSTMENTS
······························ 11
6. DIAGRAMS
······································································ 15
6-1.
Circuit Boards Location ............................................. 15
6-2.
Block Diagrams .......................................................... 16
6-3.
Printed Wiring Board MAIN Section ........................ 19
6-4.
Schematic Diagram MIAN Section (1/2) .................. 20
6-5.
Schematic Diagram MIAN Section (2/2) .................. 21
6-6.
Printed Wiring Board CASSETTE Section ............... 22
6-7.
Schematic Diagram CASSETTE Section ................. 22
6-8.
Printed Wiring Board DISPLAY Section .................. 23
6-9.
Schematic Diagram DISPLAY Section ..................... 24
6-10. Printed Wiring Board POWER Section .................... 25
6-11. Schematic Diagram POWER Section ....................... 26
6-12. IC Pin Function Description ...................................... 29
6-11. Schematic Diagram POWER Section ....................... 26
6-12. IC Pin Function Description ...................................... 29
7. EXPLODED VIEWS
······················································ 30
7-1.
Cabinet Section .......................................................... 30
7-2.
Front Panel Section -1 ................................................ 31
7-3.
Front Panel Section -2 ................................................ 32
7-4.
CD Cabinet Section .................................................... 33
8. ELECTRICAL PARTS LIST
······································· 34
Click on the first or last page to see other CMT-EP305 / HCD-EP305 service manuals if exist.