CFS-828S - Sony Audio Service Manual (repair manual). Page 9

Read Sony CFS-828S Service Manual online

9
CFS-828S
PRECAUTION
1. Clean the following parts with a denatured alcohol-moistened
swab :
record/playback head
pinch roller
erase head
rubber belts
capstan
idlers
2. Demagnetize the record/playback head with a head demagne-
tizer. (Do not bring the head demagnetizer close to the erase
head.)
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to the
parts adjusted.
5. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
6. Power supply voltage: 9 V dc.
Torque Measurement   DECK A     DECK B
Mode
Torque meter
Meter reading
2.21 to 5.39 mN • m
Forward
CQ-102C
22.5 to 55 g • cm
(0.31 to 0.76 oz • inch)
Forward
0.20 to 0.49 mN • m
back tension
CQ-102C
2 to 5 g • cm
(0.03 to 0.07 oz • inch)
Fast Forward
5.89 to 11.76 mN • m
and
CQ-201B
60 to 120 g • cm
Rewind
(0.83 to 1.67 oz • inch)
Tape Tension Measurement   DECK A     DECK B
Mode
Tension meter
Meter reading
Forward
CQ-403A
more than 150 g
(more than 5.29 oz)
SECTION 5
ELECTRICAL ADJUSTMENTS
SECTION 4
MECHANICAL ADJUSTMENTS
  TAPE SECTION     0 dB = 0.775 V
Standard Output Level
Output terminal
SP OUT
PHONES OUT
load impedance
32 
output signal level
0.775 V (0 dB)
0.25 V (–10 dB)
Test Tape
Tape
Signal
Used for
WS-48A
3 kHz, 0 dB
tape speed adjustment
Tape Speed Adjustment   DECK A     DECK B
Procedure:
• Perform normal speed adjustment before high speed check.
Mode: playback (deck A)
record (deck B)
Deck
Tape
Adjustment
Frequency
speed
point
counter
A
Normal (playback)
RV302
3,000 to 3,030 Hz
A
HI-SPEED DUBBING
(confirmation) 5,300 to 6,300 Hz
(playback)
B
HI-SPEED DUBBING
———
———
(record)
Frequency difference between the beginning and the end of the
tape should be within ± 1.0% (both Normal and Hi-speed).
Adjustment Location: – main board (component side) –
PHONES jack (J301)
set
32 
test tape
WS-48A
(3 kHz, 0 dB)
digital frequency
counter
Adjust RV301 so that reading on digital frequency counter
becomes 3,000 Hz.
Specification Value:
RV302
– MAIN board (component side) –
Page of 34
Display

Click on the first or last page to see other CFS-828S service manuals if exist.