Read Sony CFD-E77L Service Manual online
CFD-E77L
23
23
• Circuit Boards Location
KEY POWER board
JOG board
OPR/BATT LED board
TC board
KEY VOLUME board
TUNER board
MAIN board
CD board
BATY A board
BATY B board
BACK-UP board
LCD board
POWER board
AC INLET board
6-5.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
(In addition to this, the necessary note is printed in each block)
(In addition to this, the necessary note is printed in each block)
Note on Printed Wiring Board:
•
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
W
: indicates side identified with part number.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Note on Schematic Diagram:
• All capacitors are in
• All capacitors are in
µ
F unless otherwise noted. pF:
µµ
F
50 WV or less are not indicated except for electrolytics
and tantalums.
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
•
5
: fusible resistor.
•
C
: panel designation.
•
A
: B+ Line.
•
H
: adjustment for repair.
• Total current is measured with no cassette installed.
• Power voltage is dc 9V and fed with regulated dc power
• Power voltage is dc 9V and fed with regulated dc power
supply from battery terminal.
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
f
: MW/LW
E
: TAPE PLAY
a
: REC
J
: CD PLAY
Note: The components identified by mark
0
or dotted line
with mark
0
are critical for safety.
Replace only with part number specified.
Click on the first or last page to see other CFD-E77L service manuals if exist.