Read Sony CDP-XE400 / CDP-XE500 Service Manual online
– 6 –
SECTION 2
DISASSEMBLY
Note : Follow the disassembly procedure in the numerical order given.
2-1. FRONT PANEL
• When removing the front panel assembly on electric power failure,
first open the loading block by turning cam with a screwdriver as
shown in the figure, next pull out the loading block with hand, and
remove the loading panel as shown in the figure, then remove the
front panel assembly.
shown in the figure, next pull out the loading block with hand, and
remove the loading panel as shown in the figure, then remove the
front panel assembly.
3
Remove loading panel in the arrow direction.
2-2. BASE UNIT BLOCK
1
Turn the cam to direction of arrow (Counter clockwise) by
minus screw driver.
2
Take off the disc table.
3
Remove the yoke bracket.
4
Remove the MD (BU-5BD20) to the direction of arrow.
1
Turn in the direction
of the arrow.
2
Pull out disc table.
bottom of chassis
1
cam
2
disc table
4
BU-5BD20
3
yoke bracket
Click on the first or last page to see other CDP-XE400 / CDP-XE500 service manuals if exist.