Read Sony CDP-D500 Service Manual online
– 3 –
SAFETY CHECK-OUT
After correcting the original service problem, perform the follow-
ing safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs, screws,
and all other exposed metal parts for AC leakage.
Check leakage as described below.
ing safety check before releasing the set to the customer:
Check the antenna terminals, metal trim, “metallized” knobs, screws,
and all other exposed metal parts for AC leakage.
Check leakage as described below.
LEAKAGE TEST
The AC leakage from any exposed metal part to earth ground and
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microampers.). Leak-
age current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microampers.). Leak-
age current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA
WT-540A. Follow the manufacturers’ instructions to use these
instruments.
instruments.
2. A battery-operated AC milliammeter. The Data Precision 245
digital multimeter is suitable for this job.
3. Measuring the voltage drop across a resistor by means of a VOM
or battery-operated AC voltmeter. The “limit” indication is 0.75
V, so analog meters must have an accurate low-voltage scale.
The Simpson 250 and Sanwa SH-63Trd are examples of a pas-
sive VOM that is suitable. Nearly all battery operated digital
multimeters that have a 2 V AC range are suitable. (See Fig. A)
V, so analog meters must have an accurate low-voltage scale.
The Simpson 250 and Sanwa SH-63Trd are examples of a pas-
sive VOM that is suitable. Nearly all battery operated digital
multimeters that have a 2 V AC range are suitable. (See Fig. A)
1.5 k
Ω
0.15
µ
F
AC
voltmeter
(0.75 V)
voltmeter
(0.75 V)
To Exposed Metal
Parts on Set
Parts on Set
Earth Ground
Fig. A.
Using an AC voltmeter to check AC leakage.
TABLE OF CONTENTS
1.
SERVICING NOTES
...................................................
4
2.
GENERAL
.....................................................................
5
3.
DISASSEMBLY
............................................................ 13
4.
TEST MODE
................................................................. 15
5.
ELECTRICAL ADJUSTMENTS
............................ 16
6.
DIAGRAMS
6-1.
Block Diagram ................................................................... 19
6-2.
Printed Wiring Boards – CD Section – .............................. 23
6-3.
Schematic Diagram – CD Section – .................................. 25
6-4.
Printed Wiring Boards – Main Section – ........................... 28
6-5.
Schematic Diagram – Main Section – ............................... 31
6-6.
Schematic Diagram – Panel Section – ............................... 36
6-7.
Printed Wiring Boards – Panel Section – .......................... 41
6-8.
IC Pin Function Description .............................................. 46
7.
EXPLODED VIEWS
................................................... 49
8.
ELECTRICAL PARTS LIST
.................................... 54
Click on the first or last page to see other CDP-D500 service manuals if exist.