Read Sony BMZ-K2 / CX-BK2 Service Manual online
4
CX-BK2
SECTION 1
SERVICING NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
BLOCK OR BASE UNIT
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
LASER DIODE AND FOCUS SEARCH OPERATION
CHECK
CHECK
Carry out the “S curve check” in “CD section adjustment” and
check that the S curve waveforms is output three times.
check that the S curve waveforms is output three times.
SERVICE POSITION
– CD mechanism deck –
– CD mechanism deck –
•
In checking the CD mechanism deck section, prepare three extension jigs (Part No. J-2501-242-A:1.00 mm 11core/
Part No. J-2501-245-A: 1.00 mm 23 core/Part No. J-2501-248-A: 1.00mm 27 core).
Part No. J-2501-245-A: 1.00 mm 23 core/Part No. J-2501-248-A: 1.00mm 27 core).
Note:
The CD mechanism deck of this model is a vertical type and putting it vertically as shown in the figure is the standard position.
When checking signals such as RF waveforms, operate it with the CD mechanism deck in the standard position as shown below.
When checking signals such as RF waveforms, operate it with the CD mechanism deck in the standard position as shown below.
Connect the extension jig (J-2501-248-A)
to the connector board (CN701) and
the main board (CN901).
to the connector board (CN701) and
the main board (CN901).
Connect the extension jig (J-2501-242-A)
to the BD board (CN104) and the main board (CN507).
to the BD board (CN104) and the main board (CN507).
Connect the extension jig (J-2501-245-A)
to the BD board (CN102) and
the main board (CN902).
to the BD board (CN102) and
the main board (CN902).
Click on the first or last page to see other BMZ-K2 / CX-BK2 service manuals if exist.