Read Sony BM-23MK2 Service Manual online
12
BM-23MK2
SECTION 6
DIAGRAMS
•
Note for Printed Wiring Boards and Schematic Diagrams
Note on Schematic Diagram:
•
All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
and tantalums.
•
All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
2
: nonflammable resistor.
•
C
: panel designation.
•
H
: adjustment for repair.
•
A
: B+ Line.
•
Total current is measured with no cassette installed.
•
Power voltage is dc 3V and fed with regulated dc power
supply from battery terminal.
supply from battery terminal.
•
Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal production
tolerances.
tolerances.
•
Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
No mark : PB (LISTEN)
(
Voltage variations may be noted due to normal production
tolerances.
No mark : PB (LISTEN)
(
) : REC (DICT)
•
Circled numbers refer to waveforms.
•
Signal path.
E
: PB (LISTEN)
a
: REC (DICT)
Note on Printed Wiring Board:
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side A)
Pattern face side: Parts on the pattern face side seen from
(Side A)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side B)
the parts face are indicated.
Note: The components identified by mark
0
or dotted
line with mark
0
are critical for safety.
Replace only with part number specified.
1
IC701
wd
(OSC)
2.1 Vp-p
1
µ
s
1 V/DIV, 500 ns/DIV
• Waveforms
– LCD Board –
– LCD Board –
Click on the first or last page to see other BM-23MK2 service manuals if exist.