VC-S2000 (serv.man21). Operation Manual - Part 7 - More info about your VCR, Troubleshooting, extras - Sharp VCR User Guide / Operation Manual. Page 6

Read Sharp VC-S2000 (serv.man21) User Guide / Operation Manual online

51
If problems persist contact the SHARP Helpline on tel: 08705-274277 (office hours)
or www.sharp.co.uk/support
TROUBLESHOOTING
TROUBLESHOOTING
NOTE1 : Playback on PAL-60 TV
      -     : non standard mode
AREA
PROBLEM
POSSIBLE CAUSE/CURE
REMOTE 
CONTROL
The VCR can not be 
operated by remote 
control
• Remote control is too far away from the main 
unit.
• Point the remote control at the VCR.
• Batteries are flat - replace both.
• Batteries have not been inserted correctly.
• VCR is positioned in strong light.
SATELLITE
Satellite receiver does 
not respond to VCR 
commands.
• Adjust the position or angle of the satellite 
receiver.
Desired satellite 
channel can not be 
selected by the VCR.
• Re-install all channels ensuring that the satellite 
receiver is not in any special channel setting 
mode and that the desired channel is below 
channel 199 on your satellite receiver.
OTHER 
PROBLEMS
Picture does not 
change even though 
CHANNEL
 /
 buttons are 
pressed. 
• Make sure the VCR is not in Timer or Menu 
mode.
Desired channel 
position can not be 
selected.
• The channel position has been set to be 
skipped. Cancel the SKIP mode for that 
channel.
No colour or poor TV 
picture on normal 
viewing.
• Make sure all the cables are connected 
properly.
• Make sure the VCR power cord is properly 
plugged in.
Not possible to view 
picture or playback 
through RF OUT.
• Make sure the RF OUTPUT has not been switched 
off. (Refer to note on RF THROUGH ON/OFF in 
the TUNING THE TV TO THE VCR section of the 
manual.)
Desired channel has 
interference.
• Possible weak signal strength, the same channel 
with a better signal strength may have been 
tuned in on another VCR preset channel. 
Example;
VCR preset 1 = BBC1 and 
VCR preset 14 = BBC1
(Refer to Manually Sorting Channels section to 
move the channel to your desired position.)
• TV aerial may need adjusting.
No picture appears.
• Make sure the TV is on the video channel.
• Check all connecting cables.
Tape
PAL
SECAM
NTSC
Standard
Speed
Recording Play Back
Recording Play Back
Recording Play Back
S-VHS
SP
LP
EP
YES
YES
YES
YES
YES
YES
-
-
-
-
-
-
NO
-
NO
YES (Note1)
-
YES (Note1)
S-VHS ET
SP
LP
EP
YES
-
-
YES
-
-
-
-
-
-
-
-
NO
-
NO
YES (Note1)
-
YES (Note1)
VHS
SP
LP
EP
YES
YES
YES
YES
YES
YES
NO
NO
NO
NO
NO
NO
NO
-
NO
YES (Note1)
YES (Note1)
YES (Note1)
TINS-3894 ENGLISH.book  Page 51  Wednesday, September 6, 2000  11:53 AM
Page of 10
Display

Click on the first or last page to see other VC-S2000 (serv.man21) service manuals if exist.