Read Sharp VC-MH85 (serv.man12) Service Manual online
18
VC-MH705HM/LM
VC-MH815HM/LM,MH85HM
VC-MH715HM,MH835HM
VC-MH815HM/LM,MH85HM
VC-MH715HM,MH835HM
Figure 4-22.
• Replacement
1. Solder the removed PWB to the new head assembly.
2. Adjust the height from the A/C head arm (lower surface)
1. Solder the removed PWB to the new head assembly.
2. Adjust the height from the A/C head arm (lower surface)
to the A/C head plate to 10.8mm with slide calipers. (3
places of azimuth screw section, tilt screw section and A/
C head front section) (See the figure below.)
places of azimuth screw section, tilt screw section and A/
C head front section) (See the figure below.)
3. Align the left end of gear of A/C head arm with the
punched mark of chassis, tentatively tighten the screws
1
so as to ensure smooth motion of A/C head arm.
Tightening torque must be 0.45 ± 0.05N·m (4.5 ±
0.5kgf·cm).
0.5kgf·cm).
4-15 REPLACEMENT OF A/C (AUDIO/CONTROL)
HEAD
1. In eject position unplug the power cord.
•
Removal
1. Take out FFC holder from main chassis.
(Push 3 hooking point and pull-up the
holder).
holder).
2. Remove the screws
123
, Tilt screw.
3. Unsolder the PWB fitted to the A/C head.
Notes:
1. When replacing, never touch the head. If you touched,
Notes:
1. When replacing, never touch the head. If you touched,
clean with the cleaning liquid.
2. When removing the screw
3
, take care so that the
spring may out.
Figure 4-23.
Note:
1. If the screw
1. If the screw
1
is tighten tentatively too loose, the
azimuth and height of A/C head may change when they
are finally tightened. Therefore care must be taken.
are finally tightened. Therefore care must be taken.
2. After completion of A/C head be sure to adjust tape
running. (Execute the running adjustment by the method
described in 4-17.)
described in 4-17.)
Figure 4-21.
Height screw
Left end of A/C head arm gear
Punched line mark on chassis
Punched line mark on chassis
1
3
1
2
A/C head screw
Azimuth spring
Height adj. screw
A/C head PWB ass'y
(with A/E)
(with A/E)
Tilt screw
Height Adj. spring
A/C head PWB
Azimuth adj. screw
*Derection designation.
(The bottom part is big.)
(The bottom part is big.)
A/C head plate
10.8mm
A/C head FFC
A/C FFC holder
Solder
A/C head PWB
New A/C head ass'y
A/C head plate
*Fit the groove of FFC to
the boss of the holder.
the boss of the holder.
AC Head
FFC
Holder
FFC
Holder
Click on the first or last page to see other VC-MH85 (serv.man12) service manuals if exist.