Read Sharp VC-MH815 (serv.man13) Service Manual online
22
VC-MH705HM/LM
VC-MH815HM/LM,MH85HM
VC-MH715HM,MH835HM
VC-MH815HM/LM,MH85HM
VC-MH715HM,MH835HM
4-19 REPLACEMENT OF DRUM D.D. MOTOR
1. Set the ejection mode.
2. Withdraw the main power plug from the socket.
2. Withdraw the main power plug from the socket.
• Removal (Perform in numerical order.)
1. Disconnect the FFC cable
1. Disconnect the FFC cable
1
.
2. Unscrew the D.D. stator assembly fixing screws
2
.
3. Take out the D.D. stator assembly
3
.
4. Unscrew the D.D. rotor assembly fixing screws
4
.
5. Take out the D.D. rotor assembly
5
.
Notes:
1. In removing the D.D. stator assembly, part of the drum
1. In removing the D.D. stator assembly, part of the drum
earth spring pops out of the pre-load collar.
Be careful not to lose it.
Be careful not to lose it.
2. Install, so that the D.D. rotor ass'y and upper drum ass'y
mounting direction check holes align.
(Align the upper drum dent with the rotor hole.)
(Align the upper drum dent with the rotor hole.)
3. Be careful not to damage the upper drum or the video
head.
4. Protect the hole elements from shock due to contact with
D.D. stator or D.D. rotor ass'y.
5. After installation adjust the playback switching point for
adjustment of servo circuit.
4-18 REPLACEMENT OF THE CAPSTAN D.D.
(DIRECT DRIVE) MOTOR
• Remove the mechanism from the set.
• Removal (Follow the order of indicated numbers.)
1. Unsolder loading motor wire and drum FFC .
2. Remove the reel belt
1. Unsolder loading motor wire and drum FFC .
2. Remove the reel belt
1
.
3. Remove the three screws
2
.
• Reassembly
1. Taking care so that the capstan shaft does not contact
the mechanism chassis, set its position on the mecha-
nism chassis, and then install with the three screws.
nism chassis, and then install with the three screws.
2. Install the reel belt.
3. Solder loading motor wire and insert drum FFC .
3. Solder loading motor wire and insert drum FFC .
Notes:
1. After installing the capstan D.D. motor, be sure to rotate
1. After installing the capstan D.D. motor, be sure to rotate
the capstan D.D. motor and check the movement.
2. Set the tape, and check for the tape crease near the
reverse guide in the playback mode. Adjust the A/C
head and azimuth as stated in 4-17 item 2.
head and azimuth as stated in 4-17 item 2.
Figure 4-33.
Figure 4-32.
2
2
1
4
5
4
D.D. rotor ass'y
D.D.stator ass'y
Upper drum
FFC
Capstan
D.D. motor
D.D. motor
Main chassis
1
Reel belt
2
Solder drum FFC
Solder loading motor wire
Click on the first or last page to see other VC-MH815 (serv.man13) service manuals if exist.