Read Sharp VC-MH742HM (serv.man32) User Guide / Operation Manual online
GB-43
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
Normally it will not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
circumstances such as poor signal.
Ensure the video channel is selected on the TV.
1.
Press
MENU
. Press [
/
] to select
SET UP. Press
SET
to confirm.
2.
CHANNEL PRESET
will be
highlighted. Press
SET
to confirm.
3.
MANUAL TUNING
will be
highlighted. Press
SET
to confirm.
4.
PRESET
will be highlighted. Press
[
/
] to choose the required VCR
preset channel.
5.
If you have SATELLITE CONTROL set to ON
continue from point
continue from point
6
. Otherwise
continue from point
7
.
6.
Press [
/
] to select
SOURCE
. The
choose the required source:
•
If you wish to tune a satellite or cable
channel press to [
channel press to [
/
] select
SAT
.
Then press [
/
] to select
CHANNEL
. Enter preset satellite
channel using
NUMBER BUTTONS
or
[
/
] to step through each preset
satellite channel until the channel you wish is displayed.
Continue from point
Continue from point
10
.
•
If you wish to tune a terrestrial channel press to [
/
] select CH.
Continue from point
7
.
7.
Press [
/
] to select channel.
8.
Press [
/
] to start tuning in either direction. Tuning will stop when a channel is
received. If it is not the desired channel, press [
/
] to continue tuning.
9.
Press [
/
] to select
FINE TUNING
. Press and hold [
/
] until the sharpest
colour picture is obtained.
11.
Press [
/
] to select
SKIP
. The SKIP function determines whether the channel can
be selected when using
CHANNEL
[
/
] instead of the
NUMBER BUTTONS
.
12.
Press [
/
]to select ON or OFF for this option. Press
SET
to confirm.
13.
Press
MENU
to leave this function.
IMPORTANT NOTE:
10.
Press [
/
] to select the
DECODER
. This is preset to OFF. If you connect a
satellite receiver into VCR L2, as shown previously, leave decoder OFF. If you connect a
decoder, as shown previously, you must use [
decoder, as shown previously, you must use [
/
] to turn the decoder function
ON. Refer to
DECODER SWITCHING OPERATION
.
C HANN E L
P R E S E T
C HANN E L S O R T
C L O C K
P O S T C OD E
➔
P R E S E T
1
BBC 1
SOURC E CH
S A T
CHANN E L
CH 2 1
F I N E T UN I NG
D E COD E R
ON
O F F
S K I P
ON
O F F
▲
▲
If problems persist contact the SHARP Customer Helpline on tel: 0990-274277
742.book Page 43 Tuesday, August 10, 1999 1:06 PM
Click on the first or last page to see other VC-MH742HM (serv.man32) service manuals if exist.