VC-MH732HM (serv.man29). Operation manual - Sharp VCR User Guide / Operation Manual. Page 10

GB-10

.

If you replace your satellite receiver, you will need to follow the complete auto-
installation procedure to tune your VCR to the satellite receiver. This is because your 
new satellite receiver will not over-write the previous satellite channels in your VCR.

• If your satellite receiver has not changed to preset channel 12 enter the next code 

number on the list. Continue until the receiver shows preset channel 12, then continue 
from point 9.

• If your satellite receiver is not listed at the end of this manual or after entering all the 

numbers listed for your receiver, the satellite receiver preset channel has still not changed 
to 12, enter  

, and look to see if the satellite receiver has changed to preset channel 

12. If it has, continue from point 9. If not, press 

 to select

 and re-check. Continue 

until your receiver changes to preset 12, then continue from point 9.

• If there is still no response from your satellite receiver, try adjusting its position to improve 

the Infa Red VCR to satellite receiver reception.

• Auto-installation will stop when the satellite receiver reaches preset channel 199, or when 

all the 84 VCR preset channels have been used.

• The VCR will place all found terrestrial channels starting at preset 1, then all satellite 

channels from the first available preset channel after the terrestrial channels.

If you connect a satellite receiver to the VCR for the first time, after auto-installation, see 

.