VC-MH732HM (serv.man28). Operation manual - Sharp VCR User Guide / Operation Manual. Page 13

GB-9

Press [

/

], to select INPUT. L2 will be 

highlighted. 

If the VCR is not connected to the satellite 
receiver as shown in 

.

Your satellite receiver should be connected to the 
Antenna (RF in on the back of the VCR) select RF 
IN using  [

/

]  You will need to tune the VCR 

into the Satellite receiver.

Refer to 

for 

connection diagram.

Press [

/

] to select CHANNEL.

Press  [

]. The current channel will be displayed 

as a background to the on-screen display.  If this is 
not a satellite channel press [

] again. Continue 

until you see a satellite channel.

Press  [

/

]  to select SAT NO. Turn to the 

table at the end of this manual. Look for the 
make of  your satellite receiver and use the

 to enter the first code 

number listed. For example number 8 should be 
entered 0 0 8. Your satellite should now change 
to preset channel 12.

If your satellite receiver has changed to preset 
channel 12,  press 

 to confirm and the VCR 

will automatically install both satellite and 
terrestrial channels. (This may take a few minutes)
See notes on the next page if your satellite 
receiver has not changed to preset channel 12.

On completion the MOVE menu will appear 
showing the preset channel order. 
Press 

 to exit if you are happy with the 

channel order, if not and you wish to change the 
order refer to 

.

If the clock is not automatically set, the clock 
screen will appear, refer to 

 for help on setting the 

time and date.
To check the clock has been set correctly press 
the 

 button until the time appears on 

the VCR display.