Read Sharp VC-MH730HM (serv.man2) User Guide / Operation Manual online
8
INSTALLING YOUR VCR
AUTO INSTALLATION
9. Press [
] to select SAT NO. Turn to the table at the end of this manual. Look for
the make of your satellite receiver and use the NUMBER BUTTONS to enter the first
code number listed. For example number 8 should be entered 0 0 8. Your satellite
should now change to preset channel 12
code number listed. For example number 8 should be entered 0 0 8. Your satellite
should now change to preset channel 12
10.If your satellite receiver has changed to preset channel 12, the VCR will automatically
install both terrestrial and satellite channels. Press SET to confirm.
11.On completion the MOVE menu will appear showing the preset channel order. Press
MENU to exit. If the clock is not automatically set, the clock screen will appear, refer to
Manually Setting The Clock. To check the clock has been set correctly, press DISPLAY
until the time appears on the diplay. If you wish to customise the channel order refer to
Manually Sorting Channels.
Manually Setting The Clock. To check the clock has been set correctly, press DISPLAY
until the time appears on the diplay. If you wish to customise the channel order refer to
Manually Sorting Channels.
/
Notes:
If your satellite receiver has not changed to preset channel 12 enter the next code
number on the list, continue until the receiver shows preset channel 12. Then continue
from point 10.
If your satellite receiver is not listed at the end of this manual or after entering all the
numbers listed for your receiver, the satellite receiver preset channel has still not changed
to 12, enter 0 0 1, and look to see if the satellite receiver has changed to preset
channel 12. If it has, continue from point 10. If not, press
number on the list, continue until the receiver shows preset channel 12. Then continue
from point 10.
If your satellite receiver is not listed at the end of this manual or after entering all the
numbers listed for your receiver, the satellite receiver preset channel has still not changed
to 12, enter 0 0 1, and look to see if the satellite receiver has changed to preset
channel 12. If it has, continue from point 10. If not, press
to select 0 0 2 and re-
check. Continue until your receiver changes to preset 12, then continue from point 10.
●
If there is still no response from your satellite receiver, try adjusting its position to
improve the Infra Red VCR to satellite receiver reception.
improve the Infra Red VCR to satellite receiver reception.
●
Auto-installation will stop when the satellite receiver reaches preset channel 99, or when
all the 84 VCR preset channels have been used.
all the 84 VCR preset channels have been used.
●
The VCR will place all found terrestrial channels starting at preset 1, then all satellite
channels from the first available preset channel after the terrestrial channels.
channels from the first available preset channel after the terrestrial channels.
All the programmes should now be correctly tuned in and the clock set.
If you connect a satellite receiver to the VCR
for the first time, after auto-installation, see
SATELLITE RECEIVER / CABLE BOX INSTALLATION.
If you
replace your satellite receiver, you will need to follow the complete auto-
installation procedure to tune your VCR to the satellite receiver. This is because your
new satellite receiver will not over-write the previous satellite channels in your VCR.
new satellite receiver will not over-write the previous satellite channels in your VCR.
TINS-3107UMZZ VC-MH730HM 3/2/99 10:42 am Page 12
Click on the first or last page to see other VC-MH730HM (serv.man2) service manuals if exist.