Read Sharp VC-ME80HM (serv.man7) User Guide / Operation Manual online
41
➝
PRESET
BBC 1
1
SOURCE
CH/CC SAT
CHANNEL
CH21
FINE TUNING
DECODER
DECODER
ON
OFF
SKIP
ON
OFF
C H A N N E L P R E S E T
C H A N N E L S O R T
C L O C K
P O S T C O D E
C L O C K
P O S T C O D E
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
Normally it will not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
Ensure the video channel is selected on the TV
1.Press MENU. Press [
circumstances such as poor signal.
Ensure the video channel is selected on the TV
1.Press MENU. Press [
] to select
SET UP. Press SET to confirm.
2.CHANNEL PRESET will be highlighted.
Press SET to confirm.
3.MANUAL TUNING will be highlighted.
Press SET to confirm.
4.PRESET will be highlighted. Press [
]
to choose the required VCR preset channel.
5.If you have SATELLITE CONTROL set to
ON continue from point 6. Otherwise
continue from point 7.
continue from point 7.
6.Press [
] to select SOURCE. The
choose the required source:
●
If you wish to tune a satellite or cable
channel press to [
channel press to [
] select SAT.
Then press [
] to select
CHANNEL. Enter preset satellite channel
using NUMBER BUTTONS or [
using NUMBER BUTTONS or [
]
/
/
/
/
/
/
to step through each preset satellite channel until the channel you wish is displayed.
Continue from point 10.
Continue from point 10.
●
If you wish to tune a terrestrial channel press to [
] select CH.
Continue from point 7.
7.Press [
] to select channel.
8.Press [
] to start tuning in either direction. Tuning will stop when a channel is
received. If it is not the desired channel, press [
] to continue tuning.
9.Press [
] to select FINE TUNING. Press and hold [
] until the sharpest colour
picture is obtained.
/
/
/
/
/
/
IMPORTANT NOTE:
10. Press [
] to select the DECODER. This is preset to OFF. If you connect a
satellite receiver into VCR L2, as shown previously, leave decoder OFF. If you
connect a decoder, as shown previously, you must use [
connect a decoder, as shown previously, you must use [
] to turn the decoder
function ON. Refer to DECODER SWITCHING OPERATION.
/
/
▼
▼
ME-80 HM 7/12/98 12:16 pm Page 41
Click on the first or last page to see other VC-ME80HM (serv.man7) service manuals if exist.