PZ-50HV2E (serv.man8). Adjustment procedures - Sharp TV Service Manual (repair manual). Page 10

As for this adjustment, adjustment with set state is difficult.
Therefore replace it every Assy when replacing the pulse module.

Display a SUSOUT waveform

Power ON and display a SUSOUT 
waveform

Display a SUS-D waveform

Display a SUS-U waveform

Power ON and 
display a SUS-D waveform

Display a SUS-U waveform

Measuring points of waveform
are refered to next page.

Power ON
Black Mask Screen

Coarse adjustment of
SUS-U, SUS-B, SUS-G

SUS-D adjustment
Adjust the waveform to 20-25ns.

SUS-U adjustment
Adjust the waveform to 20-25ns.

Power OFF

Compare waveform, 

and do harmonize 

almost?

Yes

No

Adjust VR resistance value
of SUS-B and SUS-G to match
VR resistance value of SUS-D
within 

±

 2

Ω

.

Adjust VR resistance value
of SUS-B and SUS-G to match
VR resistance value of SUS-D
within 

±

 2

Ω

.

Power OFF

Adjustment end

SUS-D readjustment
Adjust the waveform to 20-25ns.

SUS-U readjustment
Adjust the waveform to 20-25ns.

X DRIVE

Y DRIVE

SUS-U

VR3203

VR2204

SUS-D

VR3202

VR2203

SUS-B

VR3201

VR2202

SUS-G

VR3200

VR2201

Pulse Module

X DRIVE

Y DRIVE

Upper

Lower

Upper

Lower

SUSOUT

K3105

K3106

K2212

K2203

SUS-U

K3200

K3204

K2220

K2224

SUS-D

K3108

K3205

K2207

K2225

• Pulse module loads in DRIVE Assy as one of heat measures of DRIVE Assy. Adjust the drive timing of the pulse module 

driving parallel with VR.

• Pulse module has each peculiar delay time. Readjustment is necessary when replaced the pulse module in the X and 

Y DRIVE Assys.

CR delay circuit is each inserted on signal path of four control signals (SUS-U, SUS-B, SUS-D, SUS-G) driving 
the pulse module.
Quantity of delay can adjust pulse module of one side with VR.
Adjust VR while measuring a waveform of the pulse module, and match a timing.