Read Sharp LC-65XS1E (serv.man13) Technical Bulletin online
LCD 2011 11 01
Date of Issue: 30
th
November 2011
Classification:
White
LCD TELEVISION TECHNICAL BULLETIN
Page 1 of 2
Sharp Electronics (UK) Limited
Reference – LV556
Revision - 1
White – Carry out as required
Yellow – Carry out as required and whenever the unit comes in for service
Red – Carry out on all units
MODELS
LC65XS1E
SYMPTOM Central area of screen appears to be tinted yellow.
CAUSE Software
changes.
ACTION
Only when this issue is raised, follow the given procedure below please update the
software for the LED micon.
software for the LED micon.
Figure 1. Area of possible error.
Please download from the technical web site the latest LED micon software.
1. Copy the update file “SHOWLED_108_101007.USB” into the root directly
of the USB memory device.
2. Unplug the AC code from the unit.
3. Insert the USB memory device to the USB port of the unit.
4. While pressing “POWER + MENU” keys, plug the AC code to the unit
5. Release the "POWER + MENU" keys after 3 seconds.
LCD 2011 11 01
Date of Issue: 30
th
November 2011
Classification:
White
LCD TELEVISION TECHNICAL BULLETIN
Page 2 of 2
Sharp Electronics (UK) Limited
Reference – LV556
Revision - 1
White – Carry out as required
Yellow – Carry out as required and whenever the unit comes in for service
Red – Carry out on all units
6. After a while, the update will begin and "SYSTEM UPDATE" message will
appear on the LCD.
NOTE: The LED back light does not turn on during the update process and the OSD
message will be difficult to see, to see the message use direct sunlight or another strong
light source and view from an angle.
light source and view from an angle.
7. After that, the "UPDATE success" message will appear on the LCD.
NOTE: The LED back light does not turn on during the update process and the OSD
message will be difficult to see, to see the message use direct sunlight or another strong
light source and view from an angle.
message will be difficult to see, to see the message use direct sunlight or another strong
light source and view from an angle.
8. Unplug the AC code of the unit and remove the USB memory device from
the unit.
the unit.
When units is then switched on again please Perform the “Picture
maintenance” from the menu “Setup-Identification“.
maintenance” from the menu “Setup-Identification“.
Or Follow the “Picture maintenance” in the appendix of the operation
manual.
manual.
Display