Read Sharp LC-65XS1E (serv.man10) User Guide / Operation Manual online
LC-52XS1E/RU/LC-65XS1E/RU
1 – 4
Before turning on the main power
Preparing the Display
Make sure the Display is turned off before beginning work.
Before performing work, spread cushioning over the surface on which you will be laying the Display. This will
prevent it from being damaged.
Before performing work, spread cushioning over the surface on which you will be laying the Display. This will
prevent it from being damaged.
Connecting the HDMI cable with the HDMI cable holder
•
•
•
HDMI cable
(supplied)
HDMI cable
holder
(supplied)
holder
(supplied)
Press down on the
upper hook and remove
the rear terminal cover,
pulling towards you.
upper hook and remove
the rear terminal cover,
pulling towards you.
1
Connect the HDMI cable to
the Display.
the Display.
2
Affix the HDMI cable
holder by pressing down.
holder by pressing down.
3
NOTE
These are terminals for the speaker of the TV. Do not connect any other kind of cables.
Do not disconnect the speaker cable unless absolutely necessary. If you disconnect the speaker cable, confirm each colour
of the speaker plugs and speaker terminals (the order of the colour from left to right: red/black/white) before connecting the
speaker cable again.
Do not disconnect the speaker cable unless absolutely necessary. If you disconnect the speaker cable, confirm each colour
of the speaker plugs and speaker terminals (the order of the colour from left to right: red/black/white) before connecting the
speaker cable again.
Mounting the Display on a wall
This Display should be mounted on a wall only with the wall mount bracket available from SHARP.
The use of other wall mount brackets may result in an unstable installation and may cause
serious injuries.
Mounting the Display requires special skills and should only be performed by qualified service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility
for improper mounting or mounting that results in accident or injury.
You can ask qualified service personnel about using an optional bracket to mount the Display to a wall.
To use this Display mounted on a wall, first remove the adhesive tape at the two locations on the rear of the
Display, and then use the screws supplied with the wall mount bracket to secure the bracket to the rear of the
Display.
The use of other wall mount brackets may result in an unstable installation and may cause
serious injuries.
Mounting the Display requires special skills and should only be performed by qualified service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility
for improper mounting or mounting that results in accident or injury.
You can ask qualified service personnel about using an optional bracket to mount the Display to a wall.
To use this Display mounted on a wall, first remove the adhesive tape at the two locations on the rear of the
Display, and then use the screws supplied with the wall mount bracket to secure the bracket to the rear of the
Display.
When using wall mount bracket AN-52AG8 or AN-65AG2
You can check the centre of the TV screen using the mark engraved on the wall mount bracket when mounting
the Display on the wall.
the Display on the wall.
LC-52XS1E: The centre of the TV screen is at mark “E” on the wall bracket.
LC-65XS1E: The centre of the TV screen is at mark “A” on the wall bracket.
LC-65XS1E: The centre of the TV screen is at mark “A” on the wall bracket.
Setting the Display with the optional stand
This Display should be set on a table or floor, etc. only with the stand available from SHARP, sold separately.
Be sure to follow the instructions for the stand manual.
Be sure to follow the instructions for the stand manual.
*
•
•
•
•
•
•
•
•
•
•
Speaker cable*
Click on the first or last page to see other LC-65XS1E (serv.man10) service manuals if exist.