Read Sharp LC-60LE855K (serv.man4) User Guide / Operation Manual online
6
Attaching the stand unit (for 80 inch models)
• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work, spread cushioning over the
• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
prevent it from being damaged.
• Be sure that two or more persons attach the stand.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation
• Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
• After attaching the stand to the TV, do not hold the
stand when you put up, set up, move or lay down the TV.
• Do not remove the stand from the TV unless using a
wall mount bracket to mount it.
1
Confirm that there are 14 screws (eight M6
screws, four M5 screws and two M4 screws)
supplied with the stand unit.
screws, four M5 screws and two M4 screws)
supplied with the stand unit.
2
Attach the supporting post to the stand base.
1
Insert the claws of the supporting post into
the stand base.
the stand base.
2
Secure the post and the base using the M6
screws (length: 20 mm) and a screwdriver.
screws (length: 20 mm) and a screwdriver.
M6 screws
NOTE
• Tighten the screws to the holes of the mark “b”.
3
Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
TV set.
• Instead of using a soft cushion, the cardboard box
that the TV is packed in can be assembled and
used as a work table (refer to the instructions on the
box to assemble the work table).
used as a work table (refer to the instructions on the
box to assemble the work table).
Soft cushion
4
Insert and tighten the M5 screws (length: 14 mm)
into the holes on the rear of the TV.
into the holes on the rear of the TV.
M5 screws
5
Attaching the stand cover.
1
Insert the stand cover.
2
Insert and tighten the M4 screws (length:
8 mm) into the holes of the stand cover.
8 mm) into the holes of the stand cover.
• Tighten the screws by pressing the bottom of
the stand base to the TV side.
M4 screws
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• In the installation procedure, be careful not to catch
• In the installation procedure, be careful not to catch
your fingers between the TV set and the floor.
• The TV can be rotated up to 20 degrees to the right and
left.
Preparation
Click on the first or last page to see other LC-60LE855K (serv.man4) service manuals if exist.