Read Sharp LC-52X20E (serv.man10) User Guide / Operation Manual online
Preparation
Supplied accessories
Attaching the stand unit
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1 Insert the stand into the openings on the
bottom of the TV. (Hold the stand so it will
not drop from the edge of the base area.)
2 Insert and tighten the 4 short screws into the
4 holes on the rear of the TV.
3
Confirm that there are 8 screws (4 short screws
and 4 long screws) with the stand unit.
and 4 long screws) with the stand unit.
1
Attach the supporting post for the stand unit
onto the base using the 4 long screws with the
hex key (supplied) as shown.
onto the base using the 4 long screws with the
hex key (supplied) as shown.
2
NOTE
• To detach the stand unit, perform the steps in reverse
• To detach the stand unit, perform the steps in reverse
order.
5
Remote control unit
(
g1)
AC cord
Stand unit (
g1)
Cable clamp (
g1)
Pages 3 and 6
Page 5
Page 8
Page 8
• Operation manual (This publication)
• “AAA” size battery (
g2) ... Page 6
(For Europe, except
U.K. and Eire)
(For U.K. and Eire)
U.K. type 3-pin AC cord is only included with
models LC-42X20E, LC-46X20E and LC-52X20E.
Hex key
Short
screw
screw
Long
screw
screw
Hex key
Soft
cushion
cushion
LC-42X20E-gb.indd 5
LC-42X20E-gb.indd 5
2007/09/04 16:31:18
2007/09/04 16:31:18
Click on the first or last page to see other LC-52X20E (serv.man10) service manuals if exist.