LC-46LE811E (serv.man13) - Sharp TV User Guide / Operation Manual. Page 13

When the TV is powered on for the first time after 
purchase, the initial auto installation wizard appears. 
Follow the menus and make the necessary settings one 
after another.

Is the antenna cable connected?
Is the AC cord plugged in?
Is the MAIN POWER switch turned on (;)?

E
E
E

Press <a on the TV.

The initial auto installation wizard appears.

Setting the OSD language.

Press 

a/b/c/d to select the desired language, 

and then press 

;.

Selecting the location of the TV.

HOME

STORE

Press 

c/d to select where you will use this TV, 

and then press 

;.

The confirmation screen pops up only when selecting 
“STORE”. Press 

c/d to select “Yes” or “No”.

HOME: “STANDARD” will be the default value for the “AV 
mode” setting.
STORE: “DYNAMIC (Fixed)” will be the default value for 
the “AV mode” setting. If the “AV mode” is changed, the 
TV will automatically switch back to “DYNAMIC (Fixed)” 
when there is no signal input from the TV or remote 
control unit for 30 minutes.
STORE: A demonstration image will be displayed after 
initial auto installation is completed. If you have chosen 
“STORE” by mistake, go to “Setup” > “View setting” > 
“Reset” > select “HOME” again.

•

•

•

•

•

Starting channel search.

Digital search

Analogue search

Press 

c/d to select “Digital search” or “Analogue 

search”, and then press 

;.

To watch both analogue broadcasts and digital 
broadcasts, you should perform the auto installation 
setting for each format (Page 30).
If you want to search for more broadcasts, execute 
“Additional search” from the “Programme setup” menu 
(Pages 30_32).

If you turn off the power on the TV while performing a channel 
search, the initial auto installation wizard will not appear. The 
auto installation function allows you to execute the installation 
again from “Setup” > “View setting” (Page 30).
The initial auto installation wizard will abort if you leave the TV 
unattended for 30 minutes before searching for channels.
After initial auto installation is completed, the default PIN is 
automatically set to “1234”. To change the PIN setting, refer to 
Password/Lock settings

 (Page 33). To clear the PIN setting 

(PIN input will no longer be needed), refer to CLEARING THE 
PIN

 (Page 50).

Press 

c/d to select “Terrestrial” or “Cable”, 

and then press 

;.

Terrestrial

Cable

The TV searches for, sorts and stores all the 
receivable TV stations according to their 
settings and the connected antenna.

To abort the initial auto installation in progress, press 6.

When regional services overlapps causing  conflicts where the 
services compete for the same number, the receiver displays 
a menu to allow the viewer selecting a target region for the 
conflict resolution.

•

•

•

•

•

E

•

•