LC-45GD1E (serv.man27). Adjustment procedures - Sharp TV Service Manual (repair manual). Page 5

Adjusting point

Adjusting conditions

Adjusting procedure

1

Factory setting

• Enter the process adjustment mode.
• Bring the cursor on to "INDUSTRY INIT" in page 2.
• Set to [ON] using [         (+)] or [         (–)] key, and

press [OK] to execute the initialization.
When the initialization is complete, the process
adjustment mode screen is replaced by the TUNER
screen.

•  Turn off AC power to the AVC system.

5. White balance Adjustment

1. Connect the AVC system, start the unit, and then perform a white balance adjustment on the display.
2. Using the cursor '/" key, go to the process adjustment mode page 11 and bring up the adjustment

display (High side: 200 gradations, Low side: 48 gradations).

3. Adjust [R GAMMAHI], [G GAMMAHI] and [B GAMMAHI] so that 200-gradation pattern becomes normal.
4. Adjust [R GAMMALO], [G GAMMALO] and [B GAMMALO] so that 48-gradation pattern becomes normal.

Normal pattern should be in accordance with the pattern of the standard monitor.

Reference: x = 0.272, y = 0.275 [Minolta CA-210] (200 gradations)

x = 0.272, y = 0.275 [Minolta CA-210] (48 gradations)

6. Factory Setting

Caution: When initialization is performed, all user setting data including the channel settings are initialized.
(The adjustments done in the process adjustment mode are not initialized.)

The following settings are initialized in this
adjustment.

1) User setting
2) Channel data (e.g. broadcast frequencies)
3) Operation time
4) Auto installation flag
5) Maker optional setting
6) Password data

After the adjustment, cancel the process adjustment mode.
To exit the process adjustment mode, unplug the AC power cable from the outlet to make a forced shutdown.