Read Sharp LC-40LE700E (serv.man6) Service Manual online
LC-32/40/46LE700E/RU/S,LU700E/S,LX700E/RU,LC-52LE700E/RU/S
4 – 16
15. Handling notes
Please note the following handling notes enough, when this product is used.
Moreover, please execute an enough evaluation (temperature rise and I/F match, etc.) and confirmations while installed in your product.
1. Since this product uses LED (light emitting diode). note the static electricity at handling, and do the countermeasure against static electricity of the
body grounding etc.
2. Please do not give the stress by the fall, the impact, and the accumulation of product etc. when you handle the product.
3. The installation hole must be fixed at grade, and stresses such as “Warp” and “Twist” must not join the board when you install the board. Moreover,
please do not work with the part LED, the diffusion lens, and the reflection sheet.
Please do not touch by the hand with the bord..the bar code and the serial number part...
* Otherwise, it causes scratches/dirt adhesion.
4. Please put in parallel to the connector and horizontally, and insert it in the interior surely when you insert the connector. Moreover, please use
gloves, etc. not to touch the connector terminal directory by bare-handed.
5. Please turn off the power supply and the signal input to the board unit surely, when this product is inserted in or removes from the connector.
* Otherwise, it causes the part damage.
7. When the LED unit is handling and built into the equipment, long-term storage in the oxidation or reduced gas atmosphere or the use of use of
materials such as the reagent that generates these steams of the oxidation or reduced gas, the solvent, adhesives, and resins might cause corro-
sion and discoloration.
sion and discoloration.
8. Time between turning on power and stabilizing brightness and Chromaticity. : 5min (60mA, at 25
°C).
