Read Sharp LC-40CT2E (serv.man3) User Guide / Operation Manual online
English - 5 -
Inserting Batteries in the
Remote Control
Remote Control
• Remove the battery cover located on the back of
the remote control by gently pulling backwards from
the indicated part.
the indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right directions and
replace the battery cover.
replace the battery cover.
+
+
-
-
Note: Remove the battery from remote control when it is not
to be used for a long period. Otherwise it can be damaged
due to any leakage of batteries.
to be used for a long period. Otherwise it can be damaged
due to any leakage of batteries.
Operating Range for the
Remote Control
Remote Control
• Point the top of the remote control toward the LCD
TV’s remote sensor LED while pressing a button.
SCREEN
SCREEN
LANG
LANG
SUBTTL
SUBTTL
PIP
PIP
1 2 3
4
4
6
5
9
7 8
0
RETURN
RETURN
MENU
MENU
EPG
EPG
FAV
FAV
SOURCE
SOURCE
PRESETS
PRESETS
SLEEP
SLEEP
INFO/?
INFO/?
+
+
--
V
P
OK
OK
V
--
P
+
+
30°
30°
Remote range is approximately 7m/23ft
Switching the TV On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC 50 Hz.
Please Note: On/off switch is located on the left-hand
side of the TV (from front view).
side of the TV (from front view).
• Switch the “
” button to position “|” so the TV
will switch to standby mode. Then the standby LED
lights up.
lights up.
• To switch on the TV from standby mode either:
• Touch the “
” button, P+ / P- or a numeric button
on the remote control.
• Touch the “
” or +/- button on the TV.
The TV will then switch on.
Note: If you switch on your TV via PROGRAMME UP/DOWN
buttons on the remote control or on the TV set, the programme
that you were watching last will be reselected.
buttons on the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on.
To Switch the TV Off
• Switch the “
” button to position 2 as illustrated,
so the TV will switch OFF.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Searc
can blink to indicate that features such as Standby Searc
h or
Over Air D
ownload is active.
Note: This is normal operation and is not considered as a
fault.
Note: The TV switch on time is about 23 seconds please do
not touch the ON button again during this time as this will
return the TV to Stand by mode.
fault.
Note: The TV switch on time is about 23 seconds please do
not touch the ON button again during this time as this will
return the TV to Stand by mode.
Remote Control
Sensor
A01_MB38_[GB]_3920UK_IDTV-T2_GOLD7_40883W_10067520_50164264.indd 5
A01_MB38_[GB]_3920UK_IDTV-T2_GOLD7_40883W_10067520_50164264.indd 5
25.03.2010 10:37:37
25.03.2010 10:37:37
Click on the first or last page to see other LC-40CT2E (serv.man3) service manuals if exist.