LC-39LE351K (serv.man4) - Sharp TV User Guide / Operation Manual. Page 12

Read Sharp LC-39LE351K (serv.man4) User Guide / Operation Manual online

English   - 11 -
Using a Conditional Access Module
 IMPORTANT: Insert or remove the CI module only when 
the TV is SWITCHED OFF.
In order to watch certain digital channels, a conditional 
access module (CAM) can be necessary. This module 
must be inserted in the CI slot of your TV.
1. Obtain the Conditional Access Module (CAM) and the 
viewing card by subscribing to a pay channel company, 
then insert those to the TV using the following procedure.
2. Insert the CAM and then the viewing card to the 
slot that is located in the terminal cover at the rear 
side of the TV.
3. The CAM should be correctly inserted, it is 
impossible to insert fully if reversed. The CAM or 
the TV terminal may be damaged if the CAM is 
forcefully inserted.
4. Connect the TV to the mains supply, switch on 
and then wait for few moments until the card is 
activated.
5. When no module is inserted, “No Common 
Interface module detected” message appears 
on the screen.
You can refer to the module instruction manual for details 
of the settings.
CAM 
module
Standby Notifications
If the TV does not receive any input signal (e.g. From 
an aerial or HDMI source) for 5 minutes, the TV will 
go into standby. When you next switch-on the TV, the 
following message will be displayed:
 
When the Auto Tv Off timeout is reached, the following 
message will be displayed on the screen. Select YES 
to shut down the TV. Select NO to cancel. The TV 
will switch off as well, if you do not make a selection 
on this screen.
If the TV has been left on and not been operated for 
4 hours, the TV will go into standby. When you next 
switch-on, the following message will be displayed:
Page of 42
Display

Click on the first or last page to see other LC-39LE351K (serv.man4) service manuals if exist.