Read Sharp LC-39LE350E Service Manual online
10
LC-39LE350
LC-32LE350
Operation Manual (Continued)
English - 8 -
Viewing the TV
LC-39LE350E LC-32LE350E
TV Control button & Operation
LC-39LE350E / LC-32LE350E
+
P/CH
+
TV/A
V
1. Standby button
2. TV/AV button
3. Programme Up/Down buttons
4. Volume Up/Down buttons
2. TV/AV button
3. Programme Up/Down buttons
4. Volume Up/Down buttons
, switch is used for turning the TV on or off.
Standby Notifications
1) If the TV does not receive any input signal (e.g.
from an aerial or HDMI source) for 5 minutes, the TV
will go into standby. When you next switch-on, the
following message will be displayed:
“Standby Cause
No Signal” Press OK to continue.
2) If the TV has been left on and not been operated
2) If the TV has been left on and not been operated
for a while, the TV will go into standby. When you next
switch-on, the following message will be displayed.
“Standby Cause No Operation” Press OK to
continue.
Inserting the Batteries into the Remote
Lift the cover on the back of the remote upward
gently. Install two
AAA batteries. Make sure to
match the + and - ends of the batteries in the
battery compartment (observe the correct polarity)
Replace the cover.
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable Connection
Connect the “aerial” or “cable TV” plug to AERIAL
INPUT (ANT) socket located on the back of the TV.
INPUT (ANT) socket located on the back of the TV.
Aerial or Cable
SPDIF
VGA
HDMI2
HDMI3
Click on the first or last page to see other LC-39LE350E service manuals if exist.