Read Sharp LC-32SD1E (serv.man7) Service Manual online
LC-26SD1E/RU, LC-32SD1E/RU
5 – 19
[3] Entering and exiting the adjustment process mode
1) Unplug the AC power cord of running TV set to force off the power.
2) While holding down the “VOL(-)” and ”INPUT” keys on the set at once, plug in the AC power cord to turn on the power. The letter
appears
on
the screen.
3) Next, hold down the ”VOL(-)” and ”P(
)” keys on the set at once.
Multiple lines of orange characters appearing on the screen indicate that the set is now in the adjustment Process mode. If you fail to enter the
adjustment process mode (the display is the same as normal startup), retry the procedure.
adjustment process mode (the display is the same as normal startup), retry the procedure.
4) To exit the adjustment process mode after the adjustment is done, unplug the AC power cord to force off the power. (When the power is turned off
with the remote controller, once unplug the AC power cord and plug it in again. In this case, wait 10 seconds or so before plugging.)
5) To remove “K” mode, just repeat steps 1 and 2. This time the letter K disappears from screen.
[4] Remote controller key operation and description of display in adjustment process mode.
1. key operation
* Input mode is switched automatically when relevant adjustment is started so far as the necessary input signal is available.
2. Description of display
Caution :
Use due care in handling the information described here lest the users should know how to enter the adjustment process mode. If the
settings are tampered with in this mode, unrecoverable system damage may result.
settings are tampered with in this mode, unrecoverable system damage may result.
Remote controller key
Main unit key
Function
P (
/
)
P (
/
)
Moving an item (line) by one (UP/DOWN)
VOL (+ / –)
VOL (+ / –)
Changing a selected item setting (+1/–1)
Cursor (UP/DOWN)
——————
Turing a page (PREVIOUS/NEXT)
Cursor (LEFT/RIGHT)
——————
Changing a selected line setting (+10/–10)
INPUT SOURCE
on remote controller
on remote controller
INPUT button
Input source switching (toggle switching)
(TV
(TV
→EXT1→EXT2→EXT3→EXT4→EXT5)
(Not Operative)
OK
——————
Executing a function
K
(1) Current page/Total pages (3) Currently selected input
(4) Current colour TV system
(5) Destination
Inch Setting
(32 just as example,
it may be: --/32/37)
1/11
[INFO]
TV
AUTO
32:EURO
Dev Version
Pic Version
TEMP SENSOR
Dev Loader Version
Adjustment process
menu header
(7) Parameters
1.XX (XX/XX/XXX)
(2) Current page title
NORMAL STANDBY CAUSE
ERROR STANDBY CAUSE
XX
XX
XX
XX
Main Version
XX
XX
Click on the first or last page to see other LC-32SD1E (serv.man7) service manuals if exist.