LC-32LE600E (serv.man6). Adjustment Procedure - Sharp TV Service Manual (repair manual). Page 8

LC-32/40/46LE600E/RU/S

4 – 8

Adjustment gradation values (INFO) appear on page 8/8 3-4 lines of process adjustment, and adjustment initial values (offset value) appear on pages
8/8 5-10 lines. For white balance adjustment, adjust the offset values on pages 8/8 5-10 lines.

1. Preparation

1) Luminance meter reference device                          :Minolta CA-210

2) Condition of the unit for adjustment and inspection:Modulated light: MAX (+16)

2. Setting

1) The luminance meter is set to the center of the screen of the set. 

2) In “INCH SIZE” on the process adjustment page 1/8, sets it to the size of each panel with the  /  key to R/C. 

3. Adjustment method

Check that the values of point A and B on page 8/8 of process adjustment are set as below. If not, change them accordingly.

1) Display the current adjustment status at point B. (Page 8/8 of process adjustment)

The display for checking the adjustment status is toggled by pressing the “OK” button on the remote control.

(Normal OSD display 

→ “B” → display for check (OSD disappears) → “B” → normal OSD display → ...)

2) Read the value of the luminance meter.

3) Change Point B ADJ R/Point B ADJ B (Adjustment offset value) on page 8/8 of process adjustment so that the values of the luminance meter

approach x = 0.272 and y = 0.277.

(Basically, Point B ADJ G is not changed.)

4) Follow Point A as well as item 3).

Change Point A ADJ R/Point A ADJ B (Adjustment offset value) on page 8/8 of process adjustment so that the values of the luminance meter
approach x = 0.272 and y = 0.277.

5) Select “WB WRITE” on page 8/8 in the process, set “YES”, and press the OK key of remote control.

The adjustment value is written. and then shut down the AC power.

* Initial value of RGB of point B: 3712

* Initial value of RGB of point A: based on calculated of each G point

6) [Adjustment value]

* Teaching set send by engineering dept is set as reference

4. Adjustment reference standard value

WB Point A

1280

WB Point B

3712

Point A ref. value

Point B ref. value

1280

3712

x=0.272
y=0.277
x=0.272
y=0.277

±0.001

±0.002

±0.002

±0.004

Adjustment spec 

± 0.004

Adjustment spec 

± 0.002 

Inspection spec 

± 0.006 (point 1)

Inspection spec 

± 0.004 (Excluding the above-mentioned)