Read Sharp LC-32LE361E Service Manual online
10
LC-32/40LE361
LC-32/40LE360
LC-32/40LE362
LC-32/40LE363
OPERATION MANUAL - Continued
English - 7 -
Connect Power
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow
the TV set to reach the ambient room temperature
before you connect the set to the mains. Plug the
power cable to the mains socket outlet.
Antenna/Cable/Satellite Connection
Connect the aerial or cable TV plug to the AERIAL
INPUT (ANT.) or satellite lead to the SA TELLITE
INPUT(LNB) located on the rear side of the TV.
“Satellite is only available in 362/363 series”.
Rear side of the TV:
Rear side of the TV:
SATELLITE
AERIAL
CABLE
Note: Satellite support is depending on the model.
(only available in LC-32LE363EN / LC-32LE362EN
/ LC-40LE363EN / LC-40LE362EN series)
Installing The Batteries Into The
Remote
• Remove the back cover to reveal the battery
compartment.
• Insert two size AAA batteries. Note the correct
polarity(+ or -). Do not mix old and new batteries.
Replace only with same or equivalent type.
• Place the cover back on.
Angle of the remote control unit
Use the remote control unit by pointing it towards the
remote control sensor.
Objects between the remote control unit and sensor
Objects between the remote control unit and sensor
may prevent proper operation.
Cautions regarding the remote control unit
• Do not expose the remote control unit to shock.
In addition, do not expose the remote control unit
to liquids, and do not place in an area with high
humidity.
• Do not install or place the remote control unit under
direct sunlight. The heat may cause deformation
of the unit.
• The remote control unit may not work properly if
the remote control sensor of the TV is under direct
sunlight or strong lighting. In such cases, change the
angle of the lighting or the TV, or operate the remote
control unit closer to the remote control sensor.
Switching On/Off
To Switch the TV On
Connect the power cord to the mains socket. Switch
the “
” button on the TV to position “|” so the TV
will switch to standby mode. Then the standby LED
lights up.
To switch on the TV from standby mode either:
• Press the “ ” button,
To switch on the TV from standby mode either:
• Press the “ ” button,
P+ / P- or a numeric button
on the remote control.
• Press the side function switch on the TV until the TV
comes on from standby.
The TV will then switch on.
To Switch the TV to Standby
To switch the TV to low power standby press the
“ ” button on the remote control or press the side
“ ” button on the remote control or press the side
function switch on the TV until the TV switches into
standby mode.
To Switch the TV Off
Switch the “
” button on bottom of the TV to
position 2 as illustrated - “
”, to isolate the TV from
the mains, the LED will go out.
A01_[GB]_MB90_4847UK_DVBT2_C_S_3D_PVR_CONNECTIVITY_INTERNALWIFI_OPENBROWSER_DLNA_HBBTV_MMH_ORTAK IB_WEB_REV02.indd 7
01.10.2014 17:58:35
Click on the first or last page to see other LC-32LE361E service manuals if exist.