Read Sharp LC-32GD7E (serv.man5) User Guide / Operation Manual online
24
Before leaving the upper selection lines with the blue button, select a
specifi c line. If you have switched back to station selection, you can
change this menu bar with
without having to leave the programme
list.
Programming recording (for logged in recorder)
You prepare the station marked with the
buttons for recording by
pressing the red button. In the following menu you confi rm the timer
data or change them as required. Then a red dot is set in front of this
programme in the EPG programme list as an identifi cation. If you select
this programme, you can delete the programme from the timer again
with the red button.
You can record a digitally transmitted programme and watch an analogue
programme at the same time or vice versa
✳
.
Note: Never select the sound format “Dolby Digital” during recording,
even if this is provided, since it cannot be recorded.
Call EPG menu:
Call EPG menu
EPG menu
Select provider
Select provider
Station selection
AVL Timer overview
You will fi nd the following settings in the EPG menu:
• select provider/channel • Timer overview
• Data capture
Selection of provider/station
In case of analogue TV programmes, you can change the provider (the
station which transmits EPG data) to get EPG content for other pro-
grammes. You can do this under “Select provider/channel”.
Select “Select provider/channel” and call this menu with OK. If the sta-
tion you want to change to is not listed in the “Select provider” list, start
the provider search with the green button. This takes a while.
Or, if you know the station, press the yellow button for “Change provider
list”. Select the provider in the programme list and enter it with OK and
return to the provider selection with BACK.
Select the provider in the “Select provider” menu and press OK. Then a
programme range search is performed. The programmes offered by the
provider are displayed in a list.
If you want certain programmes to be omitted from the programme
guide, you can select and deactivate these in the "Programme selec-
tion". Call the programme selection with OK. Now all programmes are
displayed (the DVB programmes too). Programmes marked by “E” are
analogue terrestrial/cable programmes, programmes marked by “D” are
digital programmes ready for the programme guide. Select the pro-
grammes you want to omit from the programme guide one after another
and deactivate each one with OK.
Data entry
After these settings or every time the switch is set off with the main
switch, the data must fi rst be collected (only for analogue TV). To do
this, select the programme which you have defi ned as a provider and
leave it switched on for about 1 hour or switch the set to standby. After
about 2 minutes the mode indicator on the TV set lights orange. The
data entry begins and lasts about 1 hour. The data are also automatically
collected between 2 and 5 in the morning when the TV is switched to
standby.
A prerequisite for data entry is that “Data capture” is “on” in the EPG
menu.
Note: If the main plug is pulled out or the ON/OFF-button is pushed, all
EPG data are lost.
If you cannot receive any EPG providers, for example, you should switch
off the data entry.
Switch on TV when marked
You can have the TV switched on automatically from standby at the be-
ginning of the memorised programme. If you are not present at the time,
a safety prompt makes sure the TV switches off again after 5 minutes.
Modes of operation
Click on the first or last page to see other LC-32GD7E (serv.man5) service manuals if exist.