LC-30HV4E (serv.man39). Using external equipment - Sharp TV User Guide / Operation Manual. Page 2

SCART cable
(commercially available)

You can use the INPUT 1 terminal when connecting a decoder and other audiovisual equipment.

To watch a decoder image, select “INPUT1” from the
“INPUT SOURCE” menu using b on the remote
control unit or INPUT on the Display.

Then select “INPUT1” on “Input Select” in the “Option”
menu to set the correct input signal type. (See page
50.)

The setting is stored and can be selected in the “INPUT
SOURCE” menu.

• Each time b is pressed, the input source toggles.
• If the decoder image does not come in clearly, you may

need to change the input signal type setting on the “Input
Select” menu.

• It is recommended to connect to the INPUT 1 terminal

when using a decoder for ground wave signal input. If
INPUT1 signals are preset in auto installation or
programme setup, make sure to set “Decoder” to
“INPUT1” in the Programme Setup “Manual” menu. (See
page 27.)

• Refer to your decoder operation manual for the signal type.

TV MENU

Option

RGB

CVBS

INPUT SOURCE

TV

INPUT1

INPUT2

INPUT3

INPUT4

PC