Read Sharp LC-26P55E (serv.man10) Service Manual online
52
LC-26GA5E
LC-32GA5E
LC-26P55E
LC-32P55E
LC-37P55E
·
IC705: POWER SUPPLY CONTROLLER FOR SIGNAL BOARD
Part number:
MR4020
Sharp code:
VHIMR4020++-1
A high speed 900V IGBT makes ideal partial resonance operation which ensures high efficiency and low noise.
Very low power consumption at micro-loads (burst mode). Start-up circuit eliminates the need for start-up resistor.
Excess current protection (ON period limitation, primary current limitation), excess voltage protection, and thermal
shut-down function are incorporated.
· IC706 & IC707: FEEDBACK CONTROL
Part number:
TA76431R
Sharp code:
VHITA76431R-1Y
Adjustable precision shunt regulator for feedback control for driving an optocoupler in power supplies.
· IC708: LOW AC MAINS VOLTAGE DETECTOR
Part number:
NJM2904M
Sharp code:
VHINJM2904M-1Y
The IC consists of two independent, high gain internally frequency compensated operation amplifiers which were
designed specifically to operate from single power supply.
IC709: +24V/+5V VOLTAGE SUPERVISOR.
Part number: NJM2903M
Sharp code: VHINJM2903M-1Y
The IC consist of two independent precision voltage comparator, high gain internally frequency compensated opera-
tion amplifiers which were designed specifically to operate from single power supply.
FD607WJ (RC/LED UNIT):
·
IC101 : OPC SENSOR
Part number:
TPS850
Sharp code:
VHITPS850++-1Y
The TPS850 is a linear-output photo-IC which incorporates a photodiode and current amp circuit in a single chip. This
photo-IC is current output type, so can set up output voltage freely by arbitrary load resistance.
FD608WJ (TUNER UNIT):
· IC201 : IF-Demodulator/PLL
Part number:
TDA9886
Sharp code:
VHITDA9886+-1Y
The TDA9886 is an alignment-free multi-standard (PAL, SECAM and NTSC) vision and sound IF signal PLL
demodulator for positive and negative modulation including sound AM and FM processing.
This IC features the following.
* Gain controlled wide-band vision intermediate frequency (VIF) amplifier (AC-coupled).
* Multi-standard true synchronous demodulation with active carrier regeneration (very linear demodulation,
good intermodulation figures reduced harmonics, excellent pulse response).
* Gate phase detector for L/L accent standard.
* Fully integrated VIF Voltage Controlled Oscillator (VCO), alignment-free; frequencies switchable for all
negative modulated standards via I2C bus.
* 4MHz reference frequency input [signal from phase-locked loop (PLL) tuning system] or operating as crystal
oscillator.
* VIF Automatic Gain Control (AGC) detector for gain control operating as a peak sync detector for negative
modulated signals and as a peak white detector for positive modulated signals.
Click on the first or last page to see other LC-26P55E (serv.man10) service manuals if exist.