LC-24LE250EK (serv.man5) - Sharp TV User Guide / Operation Manual. Page 20

Read Sharp LC-24LE250EK (serv.man5) User Guide / Operation Manual online

English   - 19 -
Troubleshooting & Tips
Tv will not turn on
Make sure the power cord is plugged in securely to 
wall outlet. The batteries in the remote control may be 
exhausted. Press the Power button on the TV. 
Poor picture
•  Have you selected the correct TV system? 
•   Low signal level can cause picture distortion.Please 
check antenna access.
•   Check if you have entered the correct channel 
frequency if you have done manual tuning. 
•  The picture quality may degrade when two devices 
are connected to the TV at the same time. In such 
a case, disconnect one of the devices.
No picture
• No Picture means that your TV is not receiving a 
transmission. Have you selected the correct button on 
the remote control? Try once more. Also make sure 
the correct input source has been selected.
•  Is the antenna connected properly? 
•  Is the antenna cable damaged? 
•  Are suitable plugs used to connect the antenna? 
•  If you are in doubt, consult your dealer.
No sound
•  Has the TV been set to mute? To cancel mute, press the 
” button, or increase the volume level.
•  Sound is coming from only one speaker. Is the balance 
set to one extreme? See Sound Menu section.
Remote control - does not operate
• The batteries may be exhausted. Replace the 
bateries. 
Input sources - can not be selected
•  If you cannot select an input source, it is possible that 
no device is connected. if not
•  Check the AV cables and connections if you have tried 
to connect a device.
Recording unavailable 
To record a programme, you should fi rst connect a 
USB disk to your TV while the TV is switched off. 
You should then switch on the TV to enable recording 
feature. If you cannot record, try switching off the TV 
and then re-inserting the USB device.
USB is too slow 
If a “USB is too slow” message is displayed on the 
screen while starting a recording, try restarting the 
recording. If you still get the same error, it is possible 
that your USB disk does not meet the speed 
requirements. Try connecting another USB disk.
A01_[GB]_MB95S_4847UK_DVBT_C_24205LED_ROCKER_SILVER16_10081844-10083115_50232547_basic IB.indd   19
A01_[GB]_MB95S_4847UK_DVBT_C_24205LED_ROCKER_SILVER16_10081844-10083115_50232547_basic IB.indd   19
28.01.2013   15:50:17
28.01.2013   15:50:17
Page of 26
Display

Click on the first or last page to see other LC-24LE250EK (serv.man5) service manuals if exist.