LC-22LE250EK (serv.man3) - Sharp TV User Guide / Operation Manual. Page 14

English   - 13 -

IMPORTANT: When using a new USB hard disk drive, 
it is recommended that you fi rst format the disk using 
your TV’s “Format Disk” option.
Note  : To record a programme, you should first 
connect a USB disk to your TV while the TV is 
switched off. You should then switch on the TV to 
enable the recording feature.

To use the recording function, you need to connect 
a USB disk or an external hard disk drive to the TV 
and the connected USB disk should have at least 1 
GB capacity and should have 2.0 speed compatibility. 
If the connected USB device does not support 2.0 
speed, an error message will be displayed.

Note: Recorded programmes are saved into the 
connected USB disk. If desired, you can store/copy 
recordings onto a computer; however, these fi les will 
not be available to be played on a computer. You can 
play the recordings only via your TV.

Note: Lip Sync delay may occur during the timeshifting. 
Radio record is supported. The TV can record 
programmes up to ten hours.

Recorded programmes are split into 4GB partitions. 

If the writing speed of the connected USB disk is not 
suffi cient, the recording may fail and the timeshifting 
feature may not be available.

It is recommended to use USB hard disk drives for 
recording HD programmes.

Do not plug out the USB/HDD during a recording. This 
may harm the connected USB/HDD.

Multipartition support is available. The maximum of 
two different partitions are supported. The fi rst partition 
of the USB disk is used for PVR ready features. It also 
must be formatted as the primary partition to be used 
for the PVR ready features.

Some stream packets may not be recorded because 
of signal problems, so sometimes video may freezes 
during playback. 

Record, Play, Pause, Display (for PlayListDialog) 
keys can not be used when teletext is ON. If a 
recording starts from timer when teletext is ON, 
teletext is automatically turned off. Also teletext usage 
is disabled when there is an ongoing recording or 
playback. 

Press 

 (PAUSE) button while watching a broadcast 

to activate timeshifting mode.In timeshifting mode, the 
programme is paused and simultaneously recorded 
to the connected USB disk. Press   (PLAY) button 
again to resume the paused programme from where 
you stopped. Press the STOP button to stop timeshift 
recording and return to the live broadcast.

Press 

 (RECORD) button to start recording an 

event instantly while watching a programme. You can 
press 

 (RECORD) button on the remote control 

again to record the next event on the EPG. In this 
case, an OSD will be displayed, indicating the 
programmed events for recording. Press 

 (STOP) 

button to cancel instant recording. 

Select the 

Recordings  Library from the Media 

Browser menu. Select a recorded item from the list (if 
previously recorded). Press the 

OK button to view the  

Play Options. Select an option then press OK button.

Press the 

 (STOP) button to stop a playback and 

return to the Recordings Library.

If you press   (PAUSE) button while watching recorded 
programmes, the slow forward feature will be available. 
You can use 

 button to slow forward. Pressing 

 

button consecutively will change slow forwarding speed.

Select the Recording Confi guration item in the 
Settings menu to confi gure the recording settings. 
Format  Disk: You can use Format Disk feature 
for formatting the connected USB disk. Your pin is 
required to use the Format Disk feature (default pin 
is 0000). 
IMPORTANT: Note that ALL the data stored on the 
USB disk will be lost and the disk format will be 
converted to FAT32 if you activate this feature. If 
your USB disk malfunctions, you can try formatting 
the USB disk. In most cases formatting the USB disk 
will restore normal operation; however, ALL the data 
stored on the USB disk will be lost in such a case. 

Note:  If “USB is too slow” message is displayed on 
the screen while starting a recording, try restarting the 
recording. If you still get the same error, it is possible that 
your USB disk does not meet the speed requirements. Try 
connecting another USB disk.

A01_[GB]_MB95S_4847UK_DVBT_C_24205LED_ROCKER_SILVER16_10081844-10083115_50232547_basic IB.indd   13

A01_[GB]_MB95S_4847UK_DVBT_C_24205LED_ROCKER_SILVER16_10081844-10083115_50232547_basic IB.indd   13

28.01.2013   15:50:16

28.01.2013   15:50:16