LC-20AD5E - Sharp TV Service Manual (repair manual). Page 13

Masking Tape
(Cotton Tape)

IC

Put Masking Tape (cotton tape) around the Flat Package
IC to protect other parts from any damage.
(Refer to Fig. 2-1.)

1.

Fig. 2-1

Some ICs on the PCB are affixed with glue, so be
careful not to break or damage the foil of each IC
leads or solder lands under the IC when removing it.

Masking is carried out on all the parts located within
10 mm distance from IC leads.

Blower type IC
desoldering machine

IC

Heat the IC leads using a blower type IC desoldering
machine. (Refer to Fig. 2-2.)

2.

Fig. 2-2

Do not rotate or move the IC back and forth , until IC
can move back and forth easily after desoldering the
leads completely.

When IC starts moving back and forth easily after
desoldering completely, pickup the corner of the IC using
tweezers and remove the IC by moving with the IC
desoldering machine. (Refer to Fig. 2-3.)

3.

Blower type IC
desoldering
machine

IC

Fig. 2-3

Tweezers

Peel off the Masking Tape.

4.

Absorb the solder left on the pattern using the Braided
Shield Wire. (Refer to Fig. 2-4.)

5.

Do not move the Braided Shield Wire in the vertical
direction towards the IC pattern.

Braided Shield Wire

Soldering Iron

Fig. 2-4

IC pattern